Suboptimal Fault Tolerant Control Design with the Use of Discrete Optimization
نویسندگان
چکیده
منابع مشابه
Suboptimal Fault Tolerant Control Design with the Use of Discrete Optimization
This paper presents a concept of designing fault tolerant control systems with the use of suboptimal methods. We assume that a given (nonlinear) dynamical process is described in a state space. The method consists in searching (at the off-line stage) for a trajectory of operational points of the system state space. The sought trajectory can be constrained by certain conditions, which can expres...
متن کاملFault-Tolerant Control of a Nonlinear Process with Input Constraints
A Fault-Tolerant Control (FTC) methodology has been presented for nonlinear processes being imposed by control input constraints. The proposed methodology uses a combination of Feedback Linearization and Model Predictive Control (FLMPC) schemes. The resulting constraints in the transformed process will be dependent on the actual evolving states, making their incorporation in the de...
متن کاملA New Design of Fault Tolerant Comparator
In this paper we have presented a new design of fault tolerant comparator with a fault free hot spare. The aim of this design is to achieve a low overhead of time and area in fault tolerant comparators. We have used hot standby technique to normal operation of the system without interrupting and dynamic recovery method in fault detection and correction. The circuit is divided to smaller modules...
متن کاملDesign of Distributed Fault Tolerant Control Systems
When dealing with large-scale complex networked control systems, designing FDI/FTC systems is a very difficult task due to the large number of sensors and actuators spatially distributed and networked connected. Despite the research effort on developing FTC systems for NCS most of these developments still being designed globally leading to centralized FTC solutions inadequate to NCS or, assume ...
متن کاملDesign of Fault Tolerant Flight Control System
The purpose of the paper is to present an approach to detect, isolate and accommodate the sensor or actuator faults using bank of observer and unknown input observers (UIO). Full order observers, reduced order observers, unknown input observers and Kalman Filter are widely used in state estimations [1]. After the estimation of states, fault detection and isolation can be provided by conducting ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Applied Mathematics and Computer Science
سال: 2008
ISSN: 1641-876X
DOI: 10.2478/v10006-008-0049-0