Supersonic Panel Flutter Boundary of Clamped Rectangular Plates
نویسندگان
چکیده
منابع مشابه
Supersonic Wind - Tunnel Flutter Tests of Two Rectangular Wings
Two rectangular wings of aspect ratio 4 were flutter tested in a supersonic wind tunnel at Mach numbers 1·6 and 2·0 using a technique in which a structural stiffness was varied to give flutter at the Mach number. The results are in reasonable agreement with calculations using theoretical three-dimensional derivatives and arbitrary wing modes, though in general the calculated critical stiffnesse...
متن کاملanalysing panel flutter in supersonic flow by hopf bifurcation
this paper is devoted to study of a partial differential equation governing panel motion in supersonic flow. this pde can be transformed to an ode by means of a galerkin method. here by using a criterion which is closely related to the routh-hurwitz criterion, we investigate the mentioned transformed ode from hopf bifurcation point of view. in fact we obtain a region for existence of simple hop...
متن کاملConduction in rectangular plates with boundary temperatures specified
Steady-state components of heat conduction solutions may have very slowly convergent series for temperatures and non-convergent heat fluxes for temperature boundary conditions. Previous papers have proposed methods to remove these convergence problems. However, even more effective procedures based on insights of Morse and Feshbach are given herein. In some cases it is possible to replace poorly...
متن کاملIntegral Transform Solution of Bending Problem of Clamped Orthotropic Rectangular Plates
The generalized integral transform technique (GITT) is employed to obtain an exact solution for the bending problem of fully clamped orthotropic rectangular plates. The use of the GITT approach in the analysis of the transverse deflection equation leads to a coupled system of fourth order differential equations in the dimensionless longitudinal spatial variable. The resulting transformed ODE sy...
متن کاملEffect of Non-ideal Boundary Conditions on Buckling of Rectangular Functionally Graded Plates
We have solved the governing equations for the buckling of rectangular functionally graded plates which one of its edges has small non-zero deflection and moment. For the case that the material properties obey a power law in the thickness direction, an analytical solution is obtained using the perturbation series. The applied in-plane load is assumed to be perpendicular to the edge which has no...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Japan Society of Aeronautical Engineering
سال: 1968
ISSN: 1883-5422
DOI: 10.2322/jjsass1953.16.224