Surface Characteristics of Polymers with Different Absorbance after UV Picosecond Pulsed Laser Processing Using Various Repetition Rates
نویسندگان
چکیده
منابع مشابه
Picosecond Laser Processing – Material Removal Rates of Metals
A picosecond laser has been used to establish the material removal rate of metals. Varied processing parameters include laser power, pulse frequency and scanning velocity. The laser beam was manipulated using a galvanometric scan head with a 100 mm focusing optic. Maximum power of the laser in the IR was 2 W and 700 mW in the UV. Scanning velocities were varied between 100 to 800 mm/s. Material...
متن کاملPicosecond Laser Processing – Material Removal Rates of Plastics
A picosecond UV laser has been used to establish the material removal rate of plastics. Varied processing parameters include laser power, pulse frequency and scanning velocity. The wave length of the laser used was 355 nm. Scanning velocity varied between 100 to 800 mm/s and repetition frequency between 10 to 500 kHz. Materials for the experiments were generally used plastics, which were availa...
متن کاملNarrow linewidth picosecond UV pulsed laser with mega-watt peak power.
We demonstrate a master oscillator power amplifier (MOPA) burst mode laser system that generates 66 ps/402.5 MHz pulses with mega-watt peak power at 355 nm. The seed laser consists of a single frequency fiber laser (linewidth < 5 KHz), a high bandwidth electro-optic modulator (EOM), a picosecond pulse generator, and a fiber based preamplifier. A very high extinction ratio (45 dB) has been achie...
متن کاملSub-picosecond UV laser ablation of metals
Laser ablation of Nickel, Copper, Molybdenum, Indium, Tungsten and Gold by short ultraviolet laser pulses (0.5 ps, 248 nm) in vacuum is reported for the first time. For Nickel and Indium, ablation is also studied in air to demonstrate the influence of the ambient atmosphere. Metal ablation in air is significantly less efficient than in vacuum due to redeposition of ablated material. The ablatio...
متن کاملSurface Micro-Structuring of Silica Glass by Laser-Induced Backside Wet Etching with ns-Pulsed UV Laser at a High Repetition Rate
Surface micro-structuring of silica glass plates was performed by using laser-induced backside wet etching (LIBWE) upon irradiation with a single-mode laser beam from a diode-pumped solidstate UV laser at 266 nm. We have succeeded in a well-defined micro-pattern formation without debris and microcrack formations around the etched area on the basis of galvanometer-based point scanning system wit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymers
سال: 2020
ISSN: 2073-4360
DOI: 10.3390/polym12092018