Surface Failure of Commercial and Experimental Restorative Resins
نویسندگان
چکیده
منابع مشابه
Surface failure of commercial and experimental restorative resins.
A single-pass test was used to study the surface failure of commercial and experimental restorative resins and composites. The surface failure observed for unfilled diacrylate resins was more severe than that seen for an unfilled acrylic resin. Addition of nonsilanated filler to the diacrylate resins increased the resistance to penetration but did not dramatically change the mode of surface fai...
متن کاملColor of dental restorative resins.
The color of 7 composite resins, an unfilled restorative resin, and 3 glaze coatings was determined by reflection spectrophotometry and visually with Munsell color tabs. Statistically significant correlations existed between comparable parameters of the spectrophotometric and Munsell data. There was observable color variations among the 11 resins studied, but only 3 materials were within the ra...
متن کاملColor Stability of Restorative Resins
The color stability of seven commercial composite resins, an unfilled resin, and three glazes was studied under conditions of accelerated aging by reflection spectrophotometry and visually with Munsell color tabs. After aging for 900 hours, most of the resins had lower values of luminous reflectance and excitation purity and higher values of dominant wavelength and contrast ratio compared to va...
متن کاملThree-dimensional surface profile analysis of different types of flowable restorative resins following different finishing protocols.
AIM The aim of this study was to investigate the surface roughness of different types of flowable restorative resins and compare the effectiveness of diamond finishing burs followed by aluminum oxide discs with aluminum oxide discs alone in producing smooth surfaces. METHODS AND MATERIALS Twenty-four specimens (10 mm X 2 mm) for each flowable resin (flowable microhybrid composite, flowable li...
متن کاملFracture toughness of composite and unfilled restorative resins.
Fracture toughness, critical strain energy release rate, and critical stress intensity factor were determined for experimental and commercial restorative resins. A composite resin had lower resistance to crack initiation than an unfilled acrylic resin. The data were consistent with surface failure observed in single-pass wear studies of these resins.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Dental Research
سال: 1976
ISSN: 0022-0345,1544-0591
DOI: 10.1177/00220345760550032201