Surface functionalization through sol-gel dip coating for thiol-mediated cell adhesion
نویسندگان
چکیده
منابع مشابه
Synergic combination of the sol–gel method with dip coating for plasmonic devices
Biosensing technologies based on plasmonic nanostructures have recently attracted significant attention due to their small dimensions, low-cost and high sensitivity but are often limited in terms of affinity, selectivity and stability. Consequently, several methods have been employed to functionalize plasmonic surfaces used for detection in order to increase their stability. Herein, a plasmonic...
متن کاملTin-doped indium oxide thin films deposited by sol–gel dip-coating technique
Indium tin oxide (ITO) thin films were prepared by the sol–gel dip-coating (SGDC) technique. The microstructure and electrical properties of ITO thin films crystallized using rapid thermal annealing (RTA) were compared with those of films prepared by classic thermal annealing (CTA). ITO thin films were successfully prepared by CTA at 500 jC for 30–60 min. At the same temperature of 500 jC and w...
متن کاملOptical parameter determination of ZrO2 thin films prepared by sol gel dip coating
Abstract : Zirconium Oxide (ZrO2) thin films were prepared on glass substrates by sol-gel dip coating method using Zirconium Oxychloride Octahydrate, Isopropanol and Acetyl acetone as precursor, solvent and stabilizer respectively. In the present work, the optical properties of the Zirconia thin films have been studied. Samples with different number of layers were prepared by repeating the dipp...
متن کاملMultiple functionalization of single-walled carbon nanotubes by dip coating.
Single walled carbon nanotubes were functionalized with different functionalities by simple dip coating. This fast and reproducible procedure was realized with nanotube coated electrodes for the construction of polyvalent biosensors. Three different pyrene derivatives were attached to the nanotube sidewalls by π-stacking interactions in a one-step reaction.
متن کاملGlass coating for PDMS microfluidic channels by sol-gel methods.
Soft lithography using polydimethylsiloxane (PDMS) allows one to fabricate complex microfluidic devices easily and at low cost. However, PDMS swells in the presence of many organic solvents significantly degrading the performance of the device. We present a method to coat PDMS channels with a glass-like layer using sol-gel chemistry. This coating greatly increases chemical resistance of the cha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Frontiers in Bioengineering and Biotechnology
سال: 2016
ISSN: 2296-4185
DOI: 10.3389/conf.fbioe.2016.01.02668