Surface Integrity Analysis in Machining of Hardened AISI 4140 Steel
نویسندگان
چکیده
منابع مشابه
On machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملSurface integrity predictions and optimisation of machining conditions in the turning of AISI H13 tool steel
Surface integrity (SI) plays a very important role in functional performance. It is dependent on a large number of machining parameters. The major concern of industry is to know which combination of machining parameters provides the best SI of machined components. Traditionally, surface roughness is considered to be the principal parameter to assess the SI of a machined part. However, residual ...
متن کاملSurface Roughness, Machining Force and FlankWear in Turning of Hardened AISI 4340 Steel with Coated Carbide Insert: Cutting Parameters Effects
The current experimental study is to investigate the effects of process parameters (cutting speed, feed rate and depth of cut) on performance characteristics (surface roughness, machining force and flank wear) in hard turning of AISI 4340 steel with multilayer CVD (TiN/TiCN/Al2O3) coated carbide insert. Combined effects of cutting parameter (v, f, d) on performance outputs (Ra, Fm and VB) ar...
متن کاملAn Investigation into the Microstructure of Adiabatic Shear Banding in AISI 1045 Hardened Steel due to High Speed Machining C.Z.Duan
Adiabatic shear banding during high speed machining is important to understand material removal mechanisms. This paper investigates the microstructure of adiabatic shear bands (ASBs) in the serrated chips produced during the high speed machining of AISI 1045 hardened steel. Optical microscope, scanning electronic microscope(SEM) and transmission electronic microscope(TEM) were used to explore t...
متن کاملInfluence of Deep Cold Rolling and Low Plasticity Burnishing on Surface Hardness and Surface Roughness of AISI 4140 Steel
Deep cold rolling (DCR) and low plasticity burnishing (LPB) process are cold working processes, which easily produce a smooth and work-hardened surface by plastic deformation of surface irregularities. The present study focuses on the surface roughness and surface hardness aspects of AISI 4140 work material, using fractional factorial design of experiments. The assessment of the surface integri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2017
ISSN: 1980-5373,1516-1439
DOI: 10.1590/1980-5373-mr-2016-0420