Surface roughness analysis of NiTi alloy in electrical discharge coating process
نویسندگان
چکیده
منابع مشابه
Surface Activation of NiTi Alloy by Using Electrochemical Process for Biomimetic Deposition of Hydroxyapatite Coating (TECHNICAL NOTE)
Electrochemical depositions of calcium phosphate (Ca-P) film on NiTi alloy in concentrated simulated body flood (SBF×5) were carried out by cathodic polarization. The Ca-P layer was successfully deposited on Ni-Ti alloy substrate under 10mA/cm2 current density for 2 hours at room temperature. Then, in order to investigate the bioactivity of the pre-calcified samples, they were immersed in SBF f...
متن کاملExperimental Study on the Surface Modification by Electrical Discharge Process
The creation of modified layer on metal surfaces using new methods is one of the procedures in surface engineering which can improve the surface mechanical properties. The electrical discharge process is a new method that can form a modified layer on the metal surfaces. This study aims to improve of pure aluminum surface properties through Electrical Discharge process with Monel 400 electrode. ...
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2020
ISSN: 1757-899X
DOI: 10.1088/1757-899x/932/1/012120