Surface Roughness ^|^mdash;The Industrial Standards and Tips on the Measuring Method^|^mdash;
نویسندگان
چکیده
منابع مشابه
THE EFFECT OF OPACIFIERS ON SURFACE ROUGHNESS OFCERAMIC GLAZES
Surface smoothness of ceramic glazes is always an important characteristic of ceramic glazes as a point of surface engineering studies. Surface roughness affects chemical resistivity, glossiness and stainabiliy of glazes. In fact, less surface roughness improves cleanability of the surface by the least usage amount of detergents. In this investigation, surface topography of two common opaque gl...
متن کاملthe effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
Validation on 3D Surface Roughness Algorithm for Measuring Roughness of Psoriasis Lesion
Psoriasis is a widespread skin disease affecting up to 2% population with plaque psoriasis accounting to about 80%. It can be identified as a red lesion and for the higher severity the lesion is usually covered with rough scale. Psoriasis Area Severity Index (PASI) scoring is the gold standard method for measuring psoriasis severity. Scaliness is one of PASI parameter that needs to be quantifie...
متن کاملMeasuring the surface roughness of sputtered coatings by microgravimetry.
A novel application of quartz crystal microgravimetry is described to enable determination of the roughness of native and sputtered oxide coatings. The technique is applicable to coatings that may be too rough for accurate atomic force microscopic imaging where measurements may be limited by the dimensions of the probe tip.
متن کاملMeasuring Copper Surface Roughness for High Speed Applications
This paper examines the use of Light Interferometry and the relevant parameters used to measure copper surface roughness before and after oxide alternative. Also discussed are the limitations and drawbacks of some of the traditional measurement parameters as they apply to copper surface roughness for conductor loss and signal integrity characterization and process control. In the PCB industry, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2012
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.78.301