Surface treated steel sheet for can stock.
نویسندگان
چکیده
منابع مشابه
Analysis of deformation-induced surface morphologies in steel sheet
The surfaces of strained mild steel sheet specimens were examined with scanning laser confocal microscopy. Rigorous assessments were employed to establish the form of the roughness data. The small deviations from the ideal conditions observed in these assessments indicated that the stochastic process responsible for surface roughening does not conform to stationary, Gaussian, Markov statistics....
متن کاملExperimental Investigation on Flame Straightening of Corrosion Resistant Structural Steel Sheet Used for Rolling Stock
Flame straightening is a common procedure used for repair work in steel components. It is based on heating a local region of the part by means of a flame torch. Due to the obstruction of the heat expansion, upsetting occurs in the work material. During cooling of the squashed zone shrinkage occurs and that is associated with tension forces which lead to the desired deformation. This process is ...
متن کاملQuantitative Characterisation of Surface Finishes on Stainless Steel Sheet Using 3d Surface Topography Analysis
Since the growth and improvement of digital computers there have been significant changesin the way that surfaces can be measured and viewed. The ‘parameter rash’ that occurred intwo-dimensional measurements [1] is being avoided by standardising 3 dimensionalparameters before the techniques have wide spread use. Huddersfield University is headingmuch of this standardisation work...
متن کاملCharacterization of a Laser Surface-Treated Martensitic Stainless Steel
Laser surface treatment was carried out on AISI 416 machinable martensitic stainless steel containing 0.225 wt.% sulfur. Nd:YAG laser with a 2.2-KW continuous wave was used. The aim was to compare the physical and chemical properties achieved by this type of selective surface treatment with those achieved by the conventional treatment. Laser power of different values (700 and 1000 W) with four ...
متن کاملThe Influence of Surface Roughness of Drawbead on Non-Symmetry Deep Drawing Cold Rolled Steel Sheet
This study was aimed to explain the influence of surface roughness of the drawbead on non-symmetry deep drawing cold rolled steel sheet to improve the drawability of cold rolled steel sheet. The variables used in this study included semi-circle drawbead with 3 levels of surface roughness which are 6.127 μm Ra, 0.963 μm Ra and 0.152 μm Ra and cold rolled steel sheet according to 3 grades of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Jitsumu Hyomen Gijutsu
سال: 1988
ISSN: 1884-3417,0368-2358
DOI: 10.4139/sfj1970.35.14