Surface Treated Steel Sheet for Containers
نویسندگان
چکیده
منابع مشابه
Analysis of deformation-induced surface morphologies in steel sheet
The surfaces of strained mild steel sheet specimens were examined with scanning laser confocal microscopy. Rigorous assessments were employed to establish the form of the roughness data. The small deviations from the ideal conditions observed in these assessments indicated that the stochastic process responsible for surface roughening does not conform to stationary, Gaussian, Markov statistics....
متن کاملQuantitative Characterisation of Surface Finishes on Stainless Steel Sheet Using 3d Surface Topography Analysis
Since the growth and improvement of digital computers there have been significant changesin the way that surfaces can be measured and viewed. The ‘parameter rash’ that occurred intwo-dimensional measurements [1] is being avoided by standardising 3 dimensionalparameters before the techniques have wide spread use. Huddersfield University is headingmuch of this standardisation work...
متن کاملCharacterization of a Laser Surface-Treated Martensitic Stainless Steel
Laser surface treatment was carried out on AISI 416 machinable martensitic stainless steel containing 0.225 wt.% sulfur. Nd:YAG laser with a 2.2-KW continuous wave was used. The aim was to compare the physical and chemical properties achieved by this type of selective surface treatment with those achieved by the conventional treatment. Laser power of different values (700 and 1000 W) with four ...
متن کاملThe Influence of Surface Roughness of Drawbead on Non-Symmetry Deep Drawing Cold Rolled Steel Sheet
This study was aimed to explain the influence of surface roughness of the drawbead on non-symmetry deep drawing cold rolled steel sheet to improve the drawability of cold rolled steel sheet. The variables used in this study included semi-circle drawbead with 3 levels of surface roughness which are 6.127 μm Ra, 0.963 μm Ra and 0.152 μm Ra and cold rolled steel sheet according to 3 grades of the ...
متن کاملLow-Carbon Steel Sheet Asymmetric Single-Point Incremental Forming: Analysis and Optimization of the Surface Roughness (TECHNICAL NOTE)
Surface roughness (SR) has an adverse effect on the appearance of low-carbon steel parts, formed in the asymmetric incremental sheet forming (AISF) process, particularly those requiring painting operation. The purpose of this study is to investigate the effects of AISF process parameters on the surface roughness of an asymmetric part formed on low-carbon steel sheets. The parameters are feed ra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1986
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.72.8_1135