Switching Characteristics of Vacuum Gap Switch Employing a UV-Laser Triggering

Vacuum Drying Characteristics of Some Vegetables

In this research the drying of four kinds of vegetables was investigated in a vacuum dryer. The effect of temperature on drying rate of samples at various temperatures (30, 35 and 45 °C) was studied. Six thin-layer drying models were fitted to drying data and suitable model was selected from them. Then effective moisture diffusivity and ...

UV-Induced Triggering of a Biomechanical Initiation Switch within Collagen Promotes Development of a Melanoma-Permissive Microenvironment in the Skin

Triggering Cell Stress and Death Using Conventional UV Laser Confocal Microscopy

Using a standard confocal setup, a UV ablation method can be utilized to selectively induce cellular injury and to visualize single-cell responses and cell-cell interactions in the CNS in real-time. Previously, studying these cell-specific responses after injury often required complicated setups or the transfer of cells or animals into different, non-physiological environments, confounding imme...

Data Link Switching: Switch-to-Switch Protocol

Status of this Memo This memo provides information for the Internet community. It does not specify an Internet standard. Distribution of this memo is unlimited. Abstract This RFC describes IBM's support of Data Link Switching over TCP/IP. The RFC is being distributed to members of the Internet community in order to solicit their reactions to the proposals contained in it. While the issues discu...

Influence of adsorbates on UV-pulsed laser melting of Si in ultra-high vacuum

The dynamics of laser melting of atomically clean Si is investigated in ultra-high-vacuum (UHV) by transient reflectivity with single-pulse sensitivity in the presence of monitored amounts of chlorine, oxygen or propene. Adsorption of one monolayer (1 ML) leads to measurable variations of the melting dynamics, which are strongly adsorbate-dependent. The variations differ qualitatively and quant...