SYNTHESIS OF DIOPSIDE BY SOLUTION COMBUSTION PROCESS USING GLYCINE FUEL

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The effect of fuel type on the synthesis of LiMn1.5Ni0.5O4 powders by solution combustion route

In this research LiMn1.5Ni0.5O4 nano powders that are used as cathode material for lithium-ion batteries were prepared by solution combustion synthesis route. Cetyl trimethyl ammonium bromide (CTAB), mixture of “CTAB and glycine” and also mixture of “CTAB and citric acid” were used as fuel using fuel to oxidant ratio of 0.5. The effect of fuel type on microstructure and electrochemical properti...

متن کامل

Enhancement of Combustion Process in Dual Fuel Engines at Part Loads by using Suitable Techniques

It is a well known fact that, dual fuel engines at part loads, inevitably suffer lower thermal efficiency, higher carbon monoxide and unburned fuel emission. The work in this paper is to investigate combustion characteristics of a dual fuel (diesel-gas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors deve...

متن کامل

New Method for Preparation of Nano Alumina Powder Using Aluminum(III) Complexes by Combustion Synthesis Without Fuel

Alumina nanomaterials were synthesized via a solution combustion technique using tris-(acetylacetonato) aluminum(III) complex (1) and tris-(2-formylphenolate) aluminum(III) complex (2) at 600, and 1000 °C for 3h. The obtained data showed that the procedure without using fuel resulted in a better phase and morphology. To investigate the phase formation, powder X-ray diffraction technique was use...

متن کامل

Thermoelectric properties of Ca0.8Dy0.2MnO3 synthesized by solution combustion process

High-quality Ca0.8Dy0.2MnO3 nano-powders were synthesized by the solution combustion process. The size of the synthesized Ca0.8Dy0.2MnO3 powders was approximately 23 nm. The green pellets were sintered at 1150-1300°C at a step size of 50°C. Sintered Ca0.8Dy0.2MnO3 bodies crystallized in the perovskite structure with an orthorhombic symmetry. The sintering temperature did not affect the Seebeck ...

متن کامل

synthesis of amido alkylnaphthols using nano-magnetic particles and surfactants

we used dbsa and nano-magnetic for the synthesis of amido alkylnaphtols.

15 صفحه اول

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: International Journal of Modern Physics: Conference Series

سال: 2013

ISSN: 2010-1945,2010-1945

DOI: 10.1142/s2010194513010155