Tailoring emission spectra by using microcavities
نویسندگان
چکیده
منابع مشابه
Stimulated secondary emission from semiconductor microcavities.
We find strong influence of final-state stimulation on the time-resolved light emission dynamics from semiconductor microcavities after pulsed excitation allowing angle-resonant polariton-polariton scattering on the lower-polariton branch. The polariton dynamics can be controlled by injection of final-state polaritons at densities below a polariton saturation density of 5x10(8) cm(-2). A bosoni...
متن کاملAsymmetric angular emission in semiconductor microcavities
P. G. Savvidis, J. J. Baumberg, R. M. Stevenson, M. S. Skolnick, D. M. Whittaker, and J. S. Roberts Department of Physics & Astronomy, University of Southampton, SO17 1BJ, United Kingdom Department of Physics, University of Sheffield, Sheffield S3 7RH, United Kingdom Toshiba Research Europe Ltd, Cambridge, CB4 4WE, United Kingdom Department of Electronic and Electrical Engineering, University o...
متن کاملSpontaneous Emission in Microcavities with Distributed Mirrors
This paper presents an analytic approach to spontaneous emission in resonators with distributed Bragg reflectors (DBR’s). The foundation of our analysis is the hard mirror (or penetration depth) approximation, which we extend to radiation with both angular and frequency distributions. This has allowed us to derive approximate analytic expressions for the divergence angle of the spontaneous emis...
متن کاملEngineering upconversion emission spectra using plasmonic nanocavities.
We show that the upconversion emission spectra of Tm³⁺ and Yb³⁺ codoped β-NaYF₄-NaYF₄ core-shell nanoparticles can be judiciously modified by means of plasmonic nanocavities. Our analysis indicates that more than a 30-fold increase in conversion efficiency to the UV spectral band can be expected by engineering the NIR absorption and the local density of states. The effect of the nanocavity on t...
متن کاملQuantum Dot Spontaneous Emission Lifetime Modification in Optical Microcavities using Oxide Apertured Micropillars
An oxide aperture is used to confine optical modes in a micropillar structure. This method overcomes the limitations due to sidewall scattering loss typical in semiconductor etched micropillars. High cavity quality factors (Q) up to 48 000 are determined by external Fabry-Perot cavity scanning measurements, a significantly higher value than prior work in III-V etched micropillars. Measured Q va...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Results in Physics
سال: 2019
ISSN: 2211-3797
DOI: 10.1016/j.rinp.2019.02.074