Technique for Electroplating of Metallic Chromium on Partially Tin-Coated Steel Sheet.
نویسندگان
چکیده
منابع مشابه
Diamond icosahedron on a TiN-coated steel substrate
Diamond layers have been deposited by hot filament chemical vapour deposition (HF CVD) on TiN-coated steel substrates. After deposition, we could observe separate, well-developed diamond icosahedrons and decahedrons on the surface. We have found that a lower content of methane in hydrogen supports their growth, this being a result of multifold twinning. The quality of diamond layers has been ev...
متن کاملCut-edge corrosion study on Al-rich metallic coated steel
Aluminium additions to metallic coatings on steel substrates have been accepted as a successful solution versus the standard zinc based coatings. The development of these products responds to the market’s demand of more versatile products, which faces the leaching effect of zinc and the rising cost of obtaining this element, among the main advantages. However, these materials show a special sen...
متن کاملA New Method for Electroplating of Crack-Free Chromium Coatings
In this study, different amounts of MoS2 particles and an anionic surfactant were added to the conventional chromium electroplating bath in order to electrodeposite crack-free chromium coatings and the structure, morphology, tribology and corrosion behavior of the deposited coatings were investigated using X-ray diffraction spectroscopy, scanning electron microscopy, pin on disk ...
متن کاملPreliminary Assessment of Chromium Emissions from Chromium Electroplating Faci Lities
The United States Environmental Protection Agency (EPA) intends to add either chromium or hexavalent chromium to the list of hazardous air pollutants under Section 112 of the Clean Air Act. A preliminary assessment performed by EPA has identified several categories of stationary sources as emitters of significant quantities of chromium to the atmosphere and for which the proposal o f national e...
متن کاملImproving Gas Sensing Properties of Tin Oxide Nanowires Palladium-Coated Using a Low Cost Technique
Thin films of SnO2 nanowires were successfully prepared by using chemical vapor deposition (CVD) process on quartz substrates. Afterwards, a thin layer of palladium (Pd) as a catalyst was coated on top of nanowires. For the deposition of Pd, a simple and low cost technique of spray pyrolysis was employed, which caused an intensive enhancement on the sensing response of fabricated sensors...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1994
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.45.88