Temperature Rise of Molten Aluminum and Zinc by Adiabatic Compression
نویسندگان
چکیده
منابع مشابه
Electrodeposition of Zinc From Low Temperature Molten Salt Electrolyte: Part I-Imidazole And Zinc-Chloride Electrolyte
Our R & D work was focused on the electro deposition of Zinc from imidazole as low temperature molten salt (LTMS) electrolyte with zinc chloride as a supporting salt at <100o C., without required controls from the previous existing non aqueous baths as well additive free system for the zinc deposition. Surface morphological studies and crystallographic orientation results were evaluated.
متن کاملEFFECT OF HIGH TEMPERATURE OXIDATION ON THE CORROSION BEHAVIOR OF ALUMINIZED LOW CARBON STEEL IN MOLTEN ALUMINUM
Hot dip aluminizing was carried out on the low carbon steel rod under optimized conditions. The aluminized samples were further oxidized at 1000̊C in air atmosphere at two different times of 20 and 60 minutes. Microstructure study and phase analysis were studied by scanning electron microscopy and X-ray diffraction methods, respectively. The characterization of the coating showed that, Fe2...
متن کاملFLOW BEHAVIOR OF MOLTEN METAL IN ALUMINUM LFC PROCESS
The effects of gating system and pattern geometry on the metal flow in the lost foam casting (LFC) process have been investigated using glass covered mold and video recording system. Unlike convectional casting process, the type of the gating system showed little effect on fillability in lost foam, but pattern thickness had large effect on mold filling. The mold filling behavior seems to be con...
متن کاملHigh-pressure Injection Injury with Molten Aluminum
INTRODUCTION A previously healthy 65-year-old male presented to the emergency department complaining of a burn to his right forearm. Just prior to arrival the patient was working at a tool and die company casting products with molten aluminum where he inadvertently caused his injury. Physical examination revealed a burn to the right forearm of varying degrees of severity. A non-painful charred ...
متن کاملAN IMPROVEMENT TO THE ANTICORROSIVE PROPERTIES OF EPOXY POWDER COATING BY ZINC PHOSPHATE AND ZINC ALUMINUM PHOSPHATE PIGMENTS
Epoxy powder coatings containing zinc aluminum phosphate (ZAP) and zinc phosphate (ZP), which are the 2nd and 1st generation of phosphate-based pigments respectively, were applied to the surface of mild steel sheets. The anticorrosive performances of the coated samples were studied using electrochemical impedance spectroscopy (EIS). Cathodic disbonding resistance and the adhesion performance of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1981
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.45.5_471