Temporal Evolution of Split-Injected Fuel Spray at Elevated Chamber Pressures
نویسندگان
چکیده
منابع مشابه
Regeneration of СO2 Physical Solvents at Elevated Pressures in Gas-Liquid Membrane Contactor
In the present work, a membrane contactor with asymmetric flat-sheet poly(vinyltrimethylsilane) (PVTMS) membranes was proposed for the CO2 desorption process from physical solvents at elevated trans-membrane pressures. Different solvents were studied: water, a mixture of polyethylene g...
متن کاملγ-Si3N4 at Elevated Temperatures and Pressures
c © 2008 by John von Neumann Institute for Computing Permission to make digital or hard copies of portions of this work for personal or classroom use is granted provided that the copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise requires prior specific permission by the publisher ment...
متن کاملStructure of Laminar Coflow Spray Flames at Different Pressures
Experiments were conducted on laminar spray diffusion flames of ethanol/argon burning in oxygen at pressures of 1 and 3 atm. The flames were physically characterized by measuring droplet velocities and sizes by phase-Doppler anemometry, and gas temperature by thin-filament pyrometry and thermocouples. The flames exhibited a cold core, where little vaporization occurred, surrounded by a primary ...
متن کاملExperimental study of the diesel injector nozzle sediment effect on fuel spray behavior
High pressure amount of fuel in new generation diesel engines’ injector equipped with multiple and small nozzle holes has created significant improvement in the outgoing spray behavior and engine performance. On the other hand, poor fuel quality and injector nozzle embedded in high temperature combustion chamber form fundamental deposits on the nozzle leading to fuel spray inappropriate behavio...
متن کاملMicrostructural Evolution of Roll Bonded Al-Clad Stainless Steel Sheets at Elevated Temperatures
The cold roll bonding of Al on AISI 304L stainless steel was carried out to fabricate the Al/304L/Al clad sheet composites. The maximum bond strength of 20 N/mm was acquired just by 38% reduction, for which the tearing of the aluminum sheet occurred during the peeling test. The microstructural evolution during subsequent postannealing heat treatment was systematically studied based on the impur...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energies
سال: 2019
ISSN: 1996-1073
DOI: 10.3390/en12224284