Tensile Behavior of High Cr Ferritic Steels
نویسندگان
چکیده
منابع مشابه
Thermal Fatigue Behavior of 400 Series Ferritic Stainless Steels
In this study, thermal fatigue properties of 400 series ferritic stainless steels have been evaluated in the temperature ranges of 200-800C and 200-900C. Systematic methods for control of temperatures within the predetermined range and measurement of load applied to specimens as a function of temperature during thermal cycles have been established. Thermal fatigue tests were conducted under ful...
متن کاملHigh heat flux testing of 12–14Cr ODS ferritic steels
0022-3115/$ see front matter 2009 Published by doi:10.1016/j.jnucmat.2009.09.022 * Corresponding author. E-mail address: [email protected] (Z. Oksiut The thermal performance of Fe–(12–14)Cr–2W–0.3Ti–0.3Y2O3 ODS reduced activation ferritic steels, which are considered as candidate first wall materials for the future fusion power reactors and were manufactured by mechanical alloying in hydr...
متن کاملThe High Temperature Tensile Properties of Ferritic-martensitic and Austenitic Steels after Irradiation in an 800 Mev Proton Beam
This study examines the effect of tensile test temperatures ranging from 50°C to 600°C on the tensile properties of a modified 9Cr-1Mo ferritic steel (T91) and a 316L stainless steel (SS) after high energy proton irradiation at about 35°C-67°C. After 1-3 dpa, the proton-irradiated T91 steel was tensile tested at temperatures from 50°C to 600°C. It was observed that the yield strength and ultima...
متن کاملDamage Behavior in Modern Automotive High Strength Dual Phase Steels During Uniaxial Tensile Deformation
In the present research, damage mechanisms during room temperature uniaxial tensile testing of two different modern high strength dual phase steels,DP780 and DP980, were studied. Detailed microstructural characterization of the strained and sectioned samples was performed by scanning electron microscopy (SEM). The results revealed that interface decohesion, especially at the triple junctions of...
متن کاملHigh Temperature Behavior of Dual Phase Steels
Dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500C. Stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500C, and smooth flow at the other temperatures. Both yield and ultimate tensile strengths increased with increasing testing temperature up to about 450<sup...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1975
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.39.3_311