Tensile creep of miniaturized specimens
نویسندگان
چکیده
منابع مشابه
Tensile and Creep Testing of Sanicro 25 Using Miniature Specimens
Tensile and creep properties of new austenitic steel Sanicro 25 at room temperature and operating temperature 700 °C were investigated by testing on miniature specimens. The results were correlated with testing on conventional specimens. Very good agreement of results was obtained, namely in yield and ultimate strength, as well as short-term creep properties. Although the creep rupture time was...
متن کاملTensile creep behaviour of polymethylpentenesilica nanocomposites
For the first time, poly(4-methyl-1-pentene) (PMP) nanocomposites were prepared by melt compounding 2 vol% of fumed silica nanoparticles, in order to study the role of the nanofiller surface area and functionalization on the tensile mechanical response of the material, with particular focus on its creep behaviour. The high optical transparency of the polymer matrix was substantially preserved i...
متن کاملTensile Creep of Polycrystalline Near-Stoichiometric NiAl
Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...
متن کاملA nano-tensile tester for creep studies
Free-standing metallic thin films are increasingly used as structural components in MEMS. In commercial devices, long-term reliability is essential, which requires determining time-dependent mechanical properties of these films. The uniaxial tensile test is a preferred method due to uncomplicated determination of the stress and strain state. However, at the MEMS-scale this method is not straigh...
متن کاملTensile Creep and Creep-Recovery Behavior of a SiC-Fiber─Si3N4-Matrix Composite
The tensile creep and creep-recovery behavior of a unidirectional Sic-fiher/Si,N,-matrix composite was investigated at 1200°C in air. A primary objective of the study was to determine how various sustained and cyclic creep loading histories would influence the creep rate, accumulated creep strain, and the amount of strain recovered upon specimen unloading. The key results obtained from the inve...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research
سال: 2017
ISSN: 0884-2914,2044-5326
DOI: 10.1557/jmr.2017.414