Tensile creep rupture at cyclic load variation
نویسندگان
چکیده
منابع مشابه
Mechanical behaviour of articular cartilage under tensile cyclic load.
INTRODUCTION Although fatigue has been implicated in cartilage failure, there are only two published studies in this area, by the same author. However, in these previous studies cartilage was tested in the direction parallel to that of collagen orientation in the superficial layer, where it possesses greater tensile strength. In the present work, articular cartilage was also tested along the di...
متن کاملA nano-tensile tester for creep studies
Free-standing metallic thin films are increasingly used as structural components in MEMS. In commercial devices, long-term reliability is essential, which requires determining time-dependent mechanical properties of these films. The uniaxial tensile test is a preferred method due to uncomplicated determination of the stress and strain state. However, at the MEMS-scale this method is not straigh...
متن کاملTensile creep behaviour of polymethylpentenesilica nanocomposites
For the first time, poly(4-methyl-1-pentene) (PMP) nanocomposites were prepared by melt compounding 2 vol% of fumed silica nanoparticles, in order to study the role of the nanofiller surface area and functionalization on the tensile mechanical response of the material, with particular focus on its creep behaviour. The high optical transparency of the polymer matrix was substantially preserved i...
متن کاملTensile Creep of Polycrystalline Near-Stoichiometric NiAl
Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...
متن کاملCreep and Creep–Rupture Behavior of Wood-Based Structural Panels
This paper summarizes a cooperative research program between the USDA Forest Service, Forest Products Laboratory (FPL), in Madison, Wisconsin, and Forintek Canada Corp. in Vancouver, British Columbia, Canada. This research program provided detailed creep–rupture and some creep information for composite panel products. Commercially produced plywood, oriented strandboard (OSB), and minimally alig...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nuclear Materials
سال: 1979
ISSN: 0022-3115
DOI: 10.1016/0022-3115(79)90039-4