Testing a low-influence spindle drive motor

A Low Cost Sensorless Control Drive Circuit for of Low Voltage Switched Reluctance Motor

Shaft position sensing is an essential part of switched reluctance (SR) motor drive In order to synchronize the pulses of phase current with the period of rising inductance of the proper motor phase. Direct sensors such as, Hall effect and optical encoder are commonly used in SR motors. The purpose of this paper is to present an indirect shaft positioning sensing known as "sensorless " control ...

Motor Parameters Influence on Stability of Drive for Industrial Robot

This paper analyzes a driving system for an industrial robot from the stability point of view. For doing this, an original analysis method has been conceived. The method has as starting point the two axes mathematical model with equations written in per unit values. A Matlab program has been conceived with their help; this program has led to results and conclusions detailed in this paper. Final...

Low cost self-synchronizing PMAC motor drive using ST7FLITE35

Increasing the Efficiency of the Power Electronic Converter for a Proposed Dual Stator Winding Squirrel-Cage Induction Motor Drive Using a Five-Leg Inverter at Low Speeds

A dual stator winding squirrel-cage induction motor (DSWIM) is a brushless single-frame induction motor that contains a stator with two isolated three-phase windings wound with dissimilar numbers of poles. Each stator winding is fed by an independent three-phase inverter. The appropriate efficiency of this motor is obtained when the ratio of two frequencies feeding the machine is equal to the r...

Intelligent-speed-increasing Spindle Using Traction Drive

INTRODUCTION Recently, a milling for die using a small end mill of diameter less than 1 mm is increased, because sizes of plastic mold parts such as connectors for an IT and an electronics becomes micro extremely. In general, a tool life is long and a good cut surface is obtained as a cutting speed is high. A speed-increasing spindle, which is attached to a shank may be used to increase the cut...