The Damping Behavior of Ni Added Mn-Cu Damping Alloys

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Transformation Behavior and its Effect on Damping Capacity in Fe-Mn Based Alloys

7 -+ E transformation behavior in a Fe-21Mn alloy with different grain size and a Fe-32Mn-6Si alloy with various degrees of wld rolling is investigated and correlated with damping capacity. Effect of microstructure on damping capacity is discussed on the assumption that the capacity is proportional to volume swept by 7 / e boundaries. 1.INTRODUCTION Fe-Mn based alloys have been well known for s...

متن کامل

Effect of Ta Additions on the Microstructure, Damping, and Shape Memory Behaviour of Prealloyed Cu-Al-Ni Shape Memory Alloys

The influence of Ta additions on the microstructure and properties of Cu-Al-Ni shape memory alloys was investigated in this paper. The addition of Ta significantly affects the green and porosity densities; the minimum percentage of porosity was observed with the modified prealloyed Cu-Al-Ni-2.0 wt.% Ta. The phase transformation temperatures were shifted towards the highest values after Ta was a...

متن کامل

EBSD Characterization of the Twinning Microstructure in a High-Damping Mn--Cu Alloy

The {101} transformation twinning bands in Mn–Cu alloys are considered to be the dominant microstructural feature contributing to the high damping capacity of the alloys. Because the face-centered-tetragonal (fct) phase of Mn–Cu alloys has an axis ratio ðc=aÞ of nearly 1, an angular resolution for Kikuchi diffraction bands of better than 0.5 is necessary to identify the twin boundaries by the e...

متن کامل

Damping Characteristics of Inherent and Intrinsic Internal Friction of Cu-Zn-Al Shape Memory Alloys

Damping properties of the inherent and intrinsic internal friction peaks (IFPT + IFI) of Cu-xZn-11Al (x = 7.0, 7.5, 8.0, 8.5, and 9.0 wt. %) shape memory alloys (SMAs) were investigated by using dynamic mechanical analysis. The Cu-7.5Zn-11Al, Cu-8.0Zn-11Al, and Cu-8.5Zn-11Al SMAs with (IFPT + IFI)β3(L21)→γ′ 3(2H) peaks exhibit higher damping capacity than the Cu-7.0Zn-11Al SMA with a (IFPT + IF...

متن کامل

Phonon softening in Ni-Mn-Ga alloys

The TA2 phonon dispersion curves of Ni-Mn-Ga alloys with different compositions which transform to different martensitic structures have been measured over a broad temperature range covering both paramagnetic and ferromagnetic phases. The branches show an anomaly (dip) at a wave number that depends on the particular martensitic structure, and there is softening of these anomalous phonons with d...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: MATERIALS TRANSACTIONS

سال: 2003

ISSN: 1345-9678,1347-5320

DOI: 10.2320/matertrans.44.1671