The Joining Characteristics of Butt Friction Stir Welded C1020/Al6063
نویسندگان
چکیده
منابع مشابه
Numerical Crack Growth Analysis in AA2024-T3 Friction Stir Welded Butt Joints
This paper deals with a numerical investigation on the influence of residual stresses on fatigue crack growth in AA2024-T3 friction stir welded butt joints. The computational approach is based on the coupled usage of the finite element method (FEM) and the dual boundary element method (DBEM), in order to take advantage of the main capabilities of the two methods. Linear elastic FE simulations a...
متن کاملThe Strength of Friction Stir Welded and Friction Stir Processed Aluminium Alloys
Local strength of friction stir (FS) welds and FS processed aluminium alloys in heat treatable aluminium alloys is dominated by precipitation hardening. Strengthening due to stored dislocations is generally limited to 40MPa, and grain size strengthening is generally less than 10MPa. Local crystallographic texture can cause yield strength variation on the order of 5%. Published models for streng...
متن کاملCorrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملEffect of tool position on microstructural and mechanical properties of friction stir butt welded joint of AA2024–AA7075 dissimilar alloys
In this research, butt joining of Al2024 and Al7075 plates were performed by Friction Stir Welding (FSW) and the effect of tool position on microstructural and mechanical properties in about 1 mm from center line of joint towards the advancing side (AS) and the retreating side (RS) was investigated at three positions of +1, 0, -1 mm. In this regard, the plates of Al2024 and Al7075 were selected...
متن کاملAutomatic seam-tracking of friction stir welded T-joints
In this research, a method for implementing automatic seam-tracking for friction stir welding, referred to hear as WeaveTrack, is presented. In this extrumum-seeking control technique, the tool weaves back and forth during welding to maintain the location where axial force is greatest, which is shown to be the center of the weld. Results demonstrate the effectiveness of this technique in tracki...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean institute of surface engineering
سال: 2009
ISSN: 1225-8024
DOI: 10.5695/jkise.2009.42.5.240