The Morphology and Fracture Properties of Thermoplastic-Toughened Epoxy Polymers
نویسندگان
چکیده
منابع مشابه
Interface Diffusion and Morphology of Aerospace Grade Epoxy Co-cured with Thermoplastic Polymers
Interfaces formed during the co-curing of an aerospace grade epoxy resin in contact with PEI, PES, and PSU surfaces are examined in this work. The interface found in each scenario is characterized by optical microscopy, and low voltage Scanning Electron Microscopy (SEM) using Energy-Dispersive X-ray spectroscopy (EDX) where applicable. Atomic Force Microscopy (AFM) in tapping mode is also used ...
متن کاملCharacterization of Thermo-Mechanical and Fracture Behaviors of Thermoplastic Polymers
In this paper the effects of the strain rate on the inelastic behavior and the self-heating under load conditions are presented for polymeric materials, such as polymethyl methacrylate (PMMA), polycarbonate (PC), and polyamide (PA66). By a torsion test, it was established that the shear yield stress behavior of PMMA, PC, and PA66 is well-described by the Ree-Eyring theory in the range of the co...
متن کاملFatigue crack propagation in microcapsule - toughened epoxy
The addition of liquid-filled urea-formaldehyde (UF) microcapsules to an epoxy matrix leads to significant reduction in fatigue crack growth rate and corresponding increase in fatigue life. Mode-I fatigue crack propagation is measured using a tapered doublecantilever beam (TDCB) specimen for a range of microcapsule concentrations and sizes: 0, 5, 10, and 20% by weight and 50, 180, and 460 lm di...
متن کاملinvestigation of the electronic properties of carbon and iii-v nanotubes
boron nitride semiconducting zigzag swcnt, $b_{cb}$$n_{cn}$$c_{1-cb-cn}$, as a potential candidate for making nanoelectronic devices was examined. in contrast to the previous dft calculations, wherein just one boron and nitrogen doping configuration have been considered, here for the average over all possible configurations, density of states (dos) was calculated in terms of boron and nitrogen ...
15 صفحه اولPredicting Wear From Mechanical Properties of Thermoplastic Polymers
The wear of polymer-based materials is connected to their brittleness. We have previously formulated a quantitative definition of brittleness in terms of elongation at break and storage modulus for thermoplastic polymers. We provide a formula connecting brittleness to viscoelastic recovery (healing) after sliding wear. Our model fits a selection of ten thermoplastics representing several classe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Adhesion
سال: 2010
ISSN: 0021-8464,1545-5823
DOI: 10.1080/00218464.2010.482415