The Newly Deposited a Cu Electrode on Ferrite Ceramics by Added Arc Glow Discharge Method.

Synthesis of Carbon Nanofibers by a Glow-arc Discharge

Effect of arc behaviour on the temperature fluctuation of carbon electrode in DC arc discharge

The Synthesis of Carbon Nano Tubes by Arc Discharge Method in Liquid media

In this investigation a simplified arc discharge apparatus was used to synthesize mullti-wall carbon nanotubes. Because of not requiring vacuum equipment, heat exchange system, active or inert gases, this method is found to be cheaper and simpler than traditional arc discharge in gas environment. Using this method, CNTs are produced by performing an arc discharge between two graphite electrodes...

Hardness and Stress of Amorphous Carbon Films Deposited by Glow Discharge and Ion Beam Assisting Deposition

The hardness and stress of amorphous carbon lms prepared by glow discharge and by ion beam assisting deposition are investigated. Relatively hard and almost stress free amorphous carbon lms were deposited by the glow discharge technique. On the other hand, by using the ion beam assisting deposition, hard lms were also obtained with a stress of the same order of those found in tetrahedral amorph...

Cation engineering of Cu-ferrite films deposited by alternating target laser ablation deposition

Epitaxial copper ferrite thin films were deposited on MgO substrates by the alternating target laser ablation deposition method. A series of films was studied to explore the impact of oxygen operating pressure, substrate temperature, and the ratio of laser shots incident on each target upon the magnetic, structural, and atomic structural properties. The highest saturation magnetization, 2800 G,...