The Response to Impulse Signal on Three Phase Transformer using Vector Network Analyzer
نویسندگان
چکیده
منابع مشابه
A Novel Transformer-Based Single-to-Three Phase Conversion Technique Using Rotating Magnetic Field Theory
This paper presents a new single to three phase converter using rotating magnetic field transformer. Conventional transformers have been used in many converters aiming at supplementary improvements and they usually have no critical effect on the conversion technique. In this paper, the conversion technique is based on a special rotating magnetic field transformer in which there are two windings...
متن کاملVector-Network-Analyzer Calibrations
We develop an uncertainty analysis that captures the dominant sources of measurement error in state-of-the-art WM-380 (WR 1.5) rectangular-waveguide vector-network-analyzer measurements over the frequency range 500–750 GHz. We use the analysis to assess thru-reflect-line, thru-short-match, and thru-short-radiating-open calibrations. The comparison shows that thru-short-match and thru-short-radi...
متن کاملLow-cost Vector Network Analyzer for Biomedical Applications
A low-cost and portable vector network analyzer (VNA) which covered operating frequency between 1MHz to 3GHz is used for vector reflection coefficient and standing wave ratio (swr) of the various microstrip antennas. This paper presents measurements of various ultra wideband (uwb) microstrip antennas for applications in biomedical field. Selection of antenna is an important key for detection of...
متن کاملElectronic Vector - Network - Analyzer Verification ■
118 October 2009 Digital Object Identifier 10.1109/MMM.2009.933595 The National Institute of Standards and Technology (NIST) recently introduced a new electronic approach for verifying microwave vectornetwork-analyzer (VNA) calibrations with a single computer-controlled electronic verifi cation artifact. The verifi cation results are captured in easy-tounderstand performance metrics that, unlik...
متن کاملClassification of transformer faults using frequency response analysis based on cross-correlation technique and support vector machine
One of the most important methods for transformers fault diagnosis (especially mechanical defects) is the frequency response analysis (FRA) method. The most important step in the FRA diagnostic process is to differentiate the faults and classify them in different classes. This paper uses the intelligent support vector machine (SVM) method to classify transformer faults. For this purpose, two gr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: KEPCO Journal on Electric Power and Energy
سال: 2015
ISSN: 2465-8111
DOI: 10.18770/kepco.2015.01.01.079