The Spiral Coaxial Cable
نویسندگان
چکیده
منابع مشابه
An Off-Center “Coaxial” Cable
A “coaxial” transmission line has inner conductor of radius a and outer conductor of radius b, but the axes of these two cylinders are offset by a small distance δ ¿ b. Deduce the capacitance and inductance per unit length, and the impedance Z, accurate to order δ/b. The (relative) dielectric constant and permeability of the medium between the two conductors both unity. The relevant frequencies...
متن کامل“Hidden” Momentum in a Coaxial Cable
Calculate the electromagnetic momentum and identify the “hidden” mechanical momentum in a coaxial cable of length L, inner radius a, outer radius b, when a battery of voltage V is connected to one end and a load resistor R0 is connected to the other. The current may be taken as uniformly distributed over the inner conductor, which has resistivity ρ. The outer conductor has negligible resistivit...
متن کاملRadiation from the Open End of a Coaxial Cable
(1) and c is the speed of light in vacuum. Estimate the time-average power P (i.e., the radiation) that escapes from the end of the cable using vector (or scalar) Huygens-Kirchhoff diffraction theory for the case that the cable is excited with a TEM wave with λ b. Compare the cases of a coaxial cable by itself, and one with its outer conductor attached to a ground plane such that the radiation ...
متن کاملCellular remote antenna feeding: Optical fibre or coaxial cable?
Introduction: It has been shown by Jung and Tonguz [1] that uplinks in personal communication system networks can be built using coaxial cable for link lengths < 0.6 – 1.4km, dependent on the cable loss. Their calculations were performed assuming cables with losses between 30 and 70dB/km at 850MHz. These low values can only be obtained using very expensive low loss cables with diameters > 1/2in...
متن کاملA Coaxial Cable Fabry-Perot Interferometer for Sensing Applications
This paper reports a novel coaxial cable Fabry-Perot interferometer for sensing applications. The sensor is fabricated by drilling two holes half-way into a coaxial cable. The device physics was described. The temperature and strain responses of the sensor were tested. The measurement error was calculated and analyzed.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Microwave Science and Technology
سال: 2015
ISSN: 1687-5826,1687-5834
DOI: 10.1155/2015/630131