The wear of a media during ultra-fine grinding.
نویسندگان
چکیده
منابع مشابه
WEAR RATE PREDICTION OF GRINDING MEDIA USING BPNN AND MLR MODELS IN GRINDING OF SULPHIDE ORES
Nowadays steel balls wear is a major problem in mineral processing industries and forms a significant part of the grinding cost. Different factors are effective on balls wear. It is needed to find models which are capable to estimate wear rate from these factors. In this paper a back propagation neural network (BPNN) and multiple linear regression (MLR) method have been used to predict wear rat...
متن کاملUltra Fine Grinding - A Practical Alternative to Oxidative Treatment of Refractory Gold Ores
Since early 2001, Kalgoorlie Consolidated Gold Mines (KCGM) has successfully operated an ultra fine grinding (UFG) circuit to supplement its roaster capacity for the treatment of the refractory gold flotation concentrate. A second UFG mill was installed in 2002 taking the total UFG capacity to over 20tph while grinding to 11-12 microns and achieving over 90% gold recovery. A development program...
متن کاملthe effect of e-64 on the developmental competence of sheep cocs during in vitro maturation
in the present study, the effect of e-64 at different concentrations (0.5, 1, 5 and 10 µm) added to (1) the ivm medium on oocyte nuclear maturation and developmental competence of ovine oocytes, and (2) to the ivc medium on embryonic development of ovine embryos were investigated.
THE EFFECT OF GRINDING TIME ON THE SPECIFIC SURFACE AREA DURING INTENSIVE GRINDING OF MINERAL POWDERS
Abstract: the changes of BET surface area of a mineral substance during intensive grinding process. Validity of the proposedmodel was tested by the experiments performed using a natural chalcopyrite mineral as well as the published data. Itwas shown that the model can predict the experimental results with a very good accuracy and can be used to predictwhat may happen under the similar experimen...
متن کاملAn investigation of the corrosive wear of steel balls in grinding of sulphide ores
Ball mills are common grinding equipment in mineral processing industries. Ball wear results from three mechanisms namely impact, abrasion and corrosion. Of these, the corrosion mechanism is the least investigated, due to its chemical-electrochemical nature. Therefore, the aims of this research were to investigate the grinding chemistry influence (slurry pH, solid percentage, water chemistry an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Powder Technology, Japan
سال: 1989
ISSN: 0386-6157,1883-7239
DOI: 10.4164/sptj.26.411