Thermal Analysis of Internally Cooled Cutting Tools.

Thermal Analysis of Air-cooled Fuel Cells

All rights reserved. However, in accordance with the Copyright Act of Canada, this work may be reproduced, without authorization, under the conditions for Fair Dealing. Therefore, limited reproduction of this work for the purposes of private study, research, criticism, review and news reporting is likely to be in accordance with the law, particularly if cited appropriately. ABSTRACT Temperature...

Eulerian-Lagrangian analysis of solid particle distribution in an internally heated and cooled air-filled cavity

Coupled FE-CFD Thermal Analysis for a Cooled Turbine Disk

This paper presents transient aero-thermal analysis for a gas turbine disk and the surrounding air flows through a transient slam acceleration/deceleration “square cycle” engine test, and compares predictions with engine measurements. The transient solid-fluid interaction calculations were performed with an innovative coupled finite element (FE) and computational fluid dynamics (CFD) approach. ...

On Stress Analysis of Diamond Coating Cutting Tools

Diamond coatings have been increasingly used in cutting tools applications. Coating delamination is the major tool failure mode and occurs due to deposition-induced residual stresses and thermomechanical loading in machining. This study applies finite element analysis to investigate stress distributions, with the edge radius focused, in diamond coating tools considering depositions and machinin...

Numerical Analysis of Rectangular Groove Cutting with Different Rc Tools

The paper reports an advanced finite element analysis code for the investigation of the cutting process of rectangular groove. Three different restricted contact tools (RC tools) with rectangular, trapezoidal and double-trapezoidal shapes were employed in this study. The cutting force, feed force and rake face temperature distribution during the cutting process were analysed. The simulation res...