Thermal Conductivity Measurement of High Conductivity Refractories by Hot Wire Method
نویسندگان
چکیده
منابع مشابه
Measurement of Thermal Conductivity of Magnesia Brick with Straight Brick Specimens by Hot Wire Method
As a result of a revision of the JIS system, the application of the hot wire method for determining thermal conductivity has been expanded from heat-insulating bricks to refractories with higher heat conductivity. In this regard, focusing on magnesia bricks, which are used in the safety lining of converters and a wide variety of other applications, the authors studied the possibility of applyin...
متن کاملThe effective thermal conductivity of wire screen
A combined experimental and theoretical investigation was conducted to examine the thermal conductivity of layers of wire mesh screen. Employing a carefully controlled sintering process, layers of sintered wire screen were examined experimentally. The experimental results indicate that the effective thermal conductivity in the z-direction (i.e., normal to the plane of the wire screen layers) fo...
متن کاملA High-Temperature Transient Hot-Wire Thermal Conductivity Apparatus for Fluids
A new apparatus for measuring both the thermal conductivity and thermal diffusivity of fluids at temperatures from 220 to 775 K at pressures to 70 MPa is described. The instrument is based on the step-power-forced transient hot-wire technique. Two hot wires are arranged in different arms of a Wheatstone bridge such that the response of the shorter compensating wire is subtracted from the respon...
متن کاملAbsolute Steady-State Thermal Conductivity Measurements by Use of a Transient Hot-Wire System
A transient hot-wire apparatus was used to measure the thermal conductivity of argon with both steady-state and transient methods. The effects of wire diameter, eccentricity of the wire in the cavity, axial conduction, and natural convection were accounted for in the analysis of the steady-state measurements. Based on measurements on argon, the relative uncertainty at the 95 % level of confiden...
متن کاملMeasuring Thermal Conductivity by Ångstrom’s Method
In this experiment, κ, the thermal conductivity of a rod of brass, was measured by periodically heating one end of the rod. Turning the heater attached to the rod on and off with a 10 mHz square wave signal, waves of heat were sent along the length of the rod, measured by two thermistors a distance ∆x apart. Taking these temperatures as a function of time, a Fourier transform was applied to a 1...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Association, Japan
سال: 1975
ISSN: 0009-0255,1884-2127
DOI: 10.2109/jcersj1950.83.26