Thermal Fatigue Properties of Austenitic Heat Resisting Steels
نویسندگان
چکیده
منابع مشابه
Low-Temperature Carburization of Austenitic Stainless Steels
LOW-TEMPERATURE CARBURIZATION is a gaseous carburization process performed at atmospheric pressure, at temperatures where the kinetics of substitutional diffusion are very slow. Low-temperature carburization hardens the surface of austenitic stainless steels through the diffusion of interstitial carbon, without the formation of carbides. The surface must be activated, by modification and remova...
متن کاملThe Fracture Mechanisms of an Austenitic Heat Resisting Steel in Copper Converter Atmosphere
The openings of Copper converter in Sarcheshmeh Copper Complex in Iranis made of a heat resisting austenitic steel (Fe-25Cr-12Ni) and many failures have been reported. Understanding the failure mechanism of the alloy helps to develop better alloys for similar complex environments. Samples of as-cast alloy and those taken from failed ones were examined. Optical Microscopy (OM), X-Ray Diffraction...
متن کاملDevelopment of Alumina-Forming Austenitic Stainless Steels
This paper presents the results of the continued development of creep-resistant, alumina-forming austenitic (AFA) stainless steel alloys, which exhibit a unique combination of excellent oxidation resistance via protective alumina (Al2O3) scale formation and high-temperature creep strength through the formation of stable nano-scale MC carbides and intermetallic precipitates. Efforts in fiscal ye...
متن کاملThermal Fatigue Behavior of 400 Series Ferritic Stainless Steels
In this study, thermal fatigue properties of 400 series ferritic stainless steels have been evaluated in the temperature ranges of 200-800C and 200-900C. Systematic methods for control of temperatures within the predetermined range and measurement of load applied to specimens as a function of temperature during thermal cycles have been established. Thermal fatigue tests were conducted under ful...
متن کاملY Studies on Austenitic Stainless Steels
Abstract--In this investigation, the fracture surfaces of SS 304 and SS 316 austenitic steels were analysed using the X-ray fractography technique. In both cases, a decrease in the austenite content was observed at the fracture surface as a result of deformation induced martensite, indicating a linear relation with Km~ within the stable crack growth region. The presence of this martensite was f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1977
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.63.5_748