Thermal processes during friction and wearing of medium carbon steel after plasma electrolytic processing
نویسندگان
چکیده
The thermal state of a frictional contact with varying normal loads and sliding speeds friction pair after plasma electrolytic processing is considered. It shown that an increase in the temperature decreases coefficient friction, wear rate tribointerface increases contact.
منابع مشابه
Microstructural refining during friction stir processing of SAF 2205 duplex stainless steel
Friction stir processing (FSP) was conducted on a SAF 2205 duplex stainless steel at advancing speed of 50 mm/min and rotational speed of 400 rpm. Characterization of evolved material was studied using electron microscopy equipped with electron back scattered diffraction (EBSD) system. The results indicated that the severe plastic deformation and the heat generated during the FSP developed a v...
متن کاملSolidification and thermal performance analysis of the low carbon steel during the continuous casting process
The present paper evaluates the effect of the nozzle characteristics on the heat transfer and phase change of the low carbon steel during the continuous casting process. A three-dimensional energy equation and a solidification model are used to drive the governing equation of the phase change and temperature distribution. A linear relation is obtained to predict the temperature-dependent of the...
متن کاملCryoelectrolysis—electrolytic processes in a frozen physiological saline medium
BACKGROUND Cryoelectrolysis is a new minimally invasive tissue ablation surgical technique that combines the ablation techniques of electrolytic ablation with cryosurgery. The goal of this study is to examine the hypothesis that electrolysis can take place in a frozen aqueous saline solution. METHOD To examine the hypothesis we performed a cryoelectrolytic ablation protocol in which electroly...
متن کاملThe Effect of Siliconizing and Borosiliconizing Processes on Microstructure and Morphology of Carbon Steel Surface Layers
A study for optimizing of siliconizing and borosiliconizing processes on carbon steels has been carried out. The process parameters, i.e, time and powder mixture, were considered for optimization of the case depth, surface quality and the hardness profile. Time and temperature of the processes were 4 hr and 950˚C, respectively. Powder mixture in siliconizing process was 2.5% ferrosilicon, 2.5%...
متن کاملThe Effect of Siliconizing and Borosiliconizing Processes on Microstructure and Morphology of Carbon Steel Surface Layers
A study for optimizing of siliconizing and borosiliconizing processes on carbon steels has been carried out. The process parameters, i.e, time and powder mixture, were considered for optimization of the case depth, surface quality and the hardness profile.
Time and temperature of the processes were 4 hr and 950˚C, respectively. Powder mixture in siliconizing process was 2.5% ferrosilicon, 2....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of physics
سال: 2021
ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']
DOI: https://doi.org/10.1088/1742-6596/1954/1/012020