Thermal Shock Resistance of Bilayered YSZ Thermal Barrier Coating

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Thermal Conductivity, Phase Stability, and Oxidation Resistance of Y3Al5O12 (YAG)/Y2O3–ZrO2 (YSZ) Thermal-Barrier Coatings

This paper describes a new multilayer TBC that incorporates a 10 μm-thick oxygen barrier layer of yttrium–aluminum garnet (YAG) into a typical YSZ TBC system. The thermal conductivity of as-sprayed YAG/YSZ coatings was reduced due to excessive porosity and amorphous areas in the YAG layer. After long-term heat treatments, the conductivity of the multilayer was unaffected by the presence of YAG....

متن کامل

Evaluation of thermal conduction anisotropy on Thermal Barrier Coating

The microstructural analysis of Thermal Barrier Coatings, deposited according to the Air Plasma Spray technology, furnishes information according which a strong orthotropic thermal conductivity is expected to be measured for such a material. Pulsed experiment with a localized heating source and thermographic temperature recording, permit to evaluate both the in-depth and in-plane components of ...

متن کامل

Thermal Conductivity of a Zirconia Thermal Barrier Coating

The conductivity of a thermal-barrier coating composed of atmospheric plasma sprayed 8 mass percent yttria partially stabilized zirconia has been measured. This coating was sprayed on a substrate of 410 stainless steel. An absolute, steady-state measurement method was used to measure thermal conductivity from 400 to 800 K. The thermal conductivity of the coating is 0.62 W/(m⋅K). This measuremen...

متن کامل

Effect of nano-structuration and compounding of YSZ APS TBCs with different thickness on coating performance in thermal shock conditions

Effect of nano-structuration and compounding of YSZ APS TBCs investigated on coating behavior in thermal shock conditions. The coatings were applied on Inconel 738 discs with three different thickness per powder. In order to harmonize the results from the samples, performance factor is defined as a criterion that in the starting of the activity has an amount of about 100 and is reduced after th...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Korean Ceramic Society

سال: 2018

ISSN: 1229-7801,2234-0491

DOI: 10.4191/kcers.2018.55.5.04