Thermoelectric performance of lanthanum telluride produced via mechanical alloying
نویسندگان
چکیده
منابع مشابه
Thermoelectric performance of lanthanum telluride produced via mechanical alloying
Andrew F. May,1 Jean-Pierre Fleurial,2 and G. Jeffrey Snyder3 1Department of Chemical Engineering, California Institute of Technology, 1200 East California Boulevard, Pasadena, California 91125, USA 2Jet Propulsion Laboratory, California Institute of Technology, 4800 Oak Grove Drive, Pasadena, California 91109, USA 3Department of Materials Science, California Institute of Technology, 1200 East ...
متن کاملThermoelectric Performance of Micro/Nano-Structured Bismuth-Antimony-Telluride Bulk from Low Cost Mechanical Alloying
In this work, micro/nano-structured Bi0.5Sb1.5Te3 bulk thermoelectric materials were synthesized by mechanical alloying from elemental shots of Bi, Sb, and Te. Cold pressing and subsequent heat treatments with hydrogen reduction were used to form bulk solid samples with good thermoelectric properties in the temperature range around 75 ̊C to 100 ̊C. In comparison to crystal growth methods and chem...
متن کاملLanthanum Telluride: Mechanochemical Synthesis of a Refractory Thermoelectric Material
Recent experimental work on lanthanum telluride has confirmed its significant potential as an n-type material for high temperature thermoelectric (TE) power generation application. The phase of interest, La3.xTe4, has a Th3P4 defect structure where x is the lanthanum vacancy with values ranging between 0 and 1/3. Thermoelectric properties change rapidly with x since the carrier concentration, «...
متن کاملHigh thermoelectric performance in copper telluride
Recently, Cu2-δS and Cu2-δSe were reported to have an ultralow thermal conductivity and high thermoelectric figure of merit zT. Thus, as a member of the copper chalcogenide group, Cu2-δTe is expected to possess superior zTs because Te is less ionic and heavy. However, the zT value is low in the Cu2Te sintered using spark plasma sintering, which is typically used to fabricate high-density bulk s...
متن کاملRaney-nickel Catalysts Produced by Mechanical Alloying
Raney catalysts were prepared by a combination of mechanical alloying and leaching as an alternative in the synthesis of Raney-Nickel catalysts. Binary Al-Ni and ternary Al-Ni-Fe alloys with nominal compositions Al65Ni35, Al75Ni25, Al65Ni30Fe5, Al75Ni20Fe5 (in atomic percent), were processed from pure elemental powders; they consisted mainly of the intermetallic B2 AlNi phase. Aluminum was sele...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review B
سال: 2008
ISSN: 1098-0121,1550-235X
DOI: 10.1103/physrevb.78.125205