Thermosetting PPE Resin with Low Dielectric Constant.
نویسندگان
چکیده
منابع مشابه
Thermosetting resins with high fractions of free volume and inherently low dielectric constants.
This work demonstrates a new class of thermosetting resins, based on Meldrum's acid (MA) derivatives, which have high fractions of free volume and inherently low k values of about 2.0 at 1 MHz. Thermal decomposition of the MA groups evolves CO2 and acetone to create air-trapped cavities so as to reduce the dielectric constants.
متن کاملFundamental Insight on Developing Low Dielectric Constant Polyimides
Thermally stable, durable, insulative polyimides are in great demand for the fabrication of microelectronic devices. In this investigation dielectric and optical properties have been studied for several series of aromatic polyimides. The effect of polarizability, fluorine content, and free volume on dielectric constant was examined. In general, minimizing polarizability, maximizing free volume ...
متن کاملELECTRICAL CONDUCTIVITY OF LOW DIELECTRIC CONSTANT LIQUIDS by
This experimental investigation was carried out in order to determine the electrical characteristics of several hydrocarbons of low dielectric constant. All measurements of the conduc ivity were below 1 picomho/m (u.10A/V-m 10-14 ohm'lcml). This category ncludes most petroleum products, petroleum distillates made conductive by adding anti-static additives, and liquified gases. Of particular int...
متن کاملLow-dielectric constant insulators for future integrated circuits and packages.
Future integrated circuits and packages will require extraordinary dielectric materials for interconnects to allow transistor advances to be translated into system-level advances. Exceedingly low-permittivity and low-loss materials are required at every level of the electronic system, from chip-level insulators to packages and printed wiring boards. In this review, the requirements and goals fo...
متن کاملDetermination of Dielectric Constant
Introduction The dielectric constant of PCB material is important in determining the trace width required to produce a characteristic impedance of 50 ohms, or any other desired impedance. The most commonly used material, FR-4, has a dielectric constant that may vary widely between manufacturers or batches, and also varies over frequency. It is useful to have a method to determine the dielectric...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Japan Institute for Interconnecting and Packaging Electronic Circuits
سال: 1995
ISSN: 1884-1201,1341-0571
DOI: 10.5104/jiep1995.10.183