Three Phase Overhead Fault Detection and Control
نویسندگان
چکیده
منابع مشابه
A Fault-Tolerant, Scalable, Low-Overhead Distributed Garbage Detection Protocol
W e present a protocol f o r the distributed detection of garbage in a distributed system subject t o common failures such as lost and duplicated messages, network partition, dismounted disks, and process, site and disk crashes. The protocol uses only information local to each site, or exchanged between pairs of sites; no global mechanism is necessary. Overhead is low. The protocol is parallel ...
متن کاملInvestigating Direct Torque Control of Six-Phase Induction Machines Under Open Phase Fault Conditions
This paper presents analysis and evaluation of classical direct torque control(DTC), for controlling a symmetrical six phase induction motor (SPIM) under open phasefault conditions. The machine has two three-phase windings spatially shifted by 60 electricaldegrees. The strategy of the proposed method consists of choosing the switching modesaccording to the configuration of living phases in such...
متن کاملFUZZY BASED FAULT DETECTION AND CONTROL FOR 6/4 SWITCHED RELUCTANCE MOTOR
Prompt detection and diagnosis of faults in industrial systems areessential to minimize the production losses, increase the safety of the operatorand the equipment. Several techniques are available in the literature to achievethese objectives. This paper presents fuzzy based control and fault detection for a6/4 switched reluctance motor. The fuzzy logic control performs like a classicalproporti...
متن کاملIntegrated Fault-detection and Control of DC Microgrids Using SDRE Observer-controller
In this paper, using the state-dependent Riccati equation (SDRE) technique, a suboptimal fault-tolerant control scheme is designed for a DC microgrid in the islanded mode. The objectives are the voltages control of the photo-voltaic cell, the battery, the capacitor bank, and the DC bus as well as on time fault detection. In the design procedure of the SDRE observer-controller, a nonlinear mathe...
متن کاملFault Tolerant Control and Fault Detection and Isolation
When a fault occurs in a system, the main problem to be addressed is to raise an alarm, ideally diagnose what fault has occurred, and then decide how to deal with it. The problem of detecting a fault, finding the source/location and then taking appropriate action is the basis of fault tolerant control. In this chapter, an introduction to fault tolerant control (FTC) and fault detection and isol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2018
ISSN: 2321-9653
DOI: 10.22214/ijraset.2018.3165