Time reversal seismic source imaging using peak average power ratio (PAPR) parameter
نویسندگان
چکیده
منابع مشابه
Peak-to-Average-Power-Ratio (PAPR) reduction in WiMAX and OFDM/A systems
A peak to average power ratio (PAPR) reduction method is proposed that exploits the precoding or beamforming mode in WiMAX. The method is applicable to any OFDM/A systems that implements beamforming using dedicated pilots which use the same beamforming antenna weights for both pilots and data. Beamforming performance depends on the relative phase shift between antennas, but is unaffected by a p...
متن کاملInvestigating of The Reducing Techniques for The Peak to Average Power Ratio(PAPR) in OFDM Systems
High Peak to Average Power Ratio (PAPR) for OFDM system is still a demanding area and difficult issue. The radio transmitter stations for covering and getting enough transmit power in their desired area have to use High Power Amplifier (HPA). On the other hand, in order the HPA have the most output power efficiency must be designed to work close to the saturation region therefore due to the hig...
متن کاملPeak to Average Power Ratio (papr) Reduction in Ofdm Based Radio Systems
.................................................................................................................................................. 3 Acknowledgement .................................................................................................................................. 4 Table of
متن کاملPeak to Average Power Ratio (papr) Reduction Techniques for Ofdm-mimo System
In the previous chapter, to get high data rate transmission, High Throughput techniques were analyzed for OFDM-MIMO System. OFDMMIMO systems based on OFDM symbols suffer from the problem of inherent Peak to Average Power Ratio (PAPR). The peak power of a multi carrier OFDM signal is a critical design factor for band limited communication systems, and it is necessary to reduce it as much as poss...
متن کاملLinear Precoder Design To Minimize Peak To Average Power Ratio (PAPR) For MIMO-OFDM System
We propose a direct precoding plan for a solitary client numerous input–multiple-yield Orthogonal Frequency Division Multiplexing (OFDM) framework to minimize top to normal force degree (PAPR) by utilizing repetitive spatial assets at the transmitter through a particular worth decay based summed up converse. The proposed precoder focused around the summed up converse is made out of two sections...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Geophysica
سال: 2017
ISSN: 1895-6572,1895-7455
DOI: 10.1007/s11600-017-0022-0