Tool edge radius effect on cutting temperature in micro-end-milling process
نویسندگان
چکیده
منابع مشابه
Modeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملCutting Force Prediction in End Milling Process of AISI 304 Steel Using Solid Carbide Tools
In the present study, an attempt has been made to experimentally investigate the effects of cutting parameters on cutting force in end milling of AISI 304 steel with solid carbide tools. Experiments were conducted based on four factors and five level central composite rotatable design. Mathematical model has been developed to predict the cutting forces in terms of cutting parameters such as he...
متن کاملModeling micro - end - milling operations . Part II : tool run - out
The effect of run-out is clearly noticed in micro-end-milling operations, while the same run-out creates negligible change at the cutting force profile of conventional end-milling operations. In this paper, the cutting force characteristics of micro-end-milling operations with tool run-out are investigated. An analytical cutting force model is developed for micro-end-milling operations with too...
متن کاملFuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملModelling and Numerical Simulation of Cutting Stress in End Milling of Titanium Alloy using Carbide Coated Tool
Based on the cutting force theory, the cutting stress in end milling operation was predicted satisfactorily through simulation of using finite element method. The mechanistic force models were introduced in high accuracy force predictions for most applications. The material properties in the simulations were defined based on the cutting force theory, as a function of strain and strain rate wher...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Journal of Advanced Manufacturing Technology
سال: 2010
ISSN: 0268-3768,1433-3015
DOI: 10.1007/s00170-010-2795-z