Tool wear in dry gear hobbing of 20MnCr5 case-hardening steel, 42CrMo4 tempered steel and EN-GJS-700-2 cast iron
نویسندگان
چکیده
منابع مشابه
Dry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملInvestigation of Wear Mechanism in Quenched and Tempered Medium Carbon-High Chromium Martensitic Steel Using Dry Sand/Rubber Wheel
The aim of the present study was to investigate the effect of quenching and tempering temperatures on the microstructure, mechanical properties and the wear characteristics of medium carbon-high chromium wear resistant steel. In addition, the dominant wear mechanisms were studied. For this purpose, austenitizing and tempering temperatures were selected in the ranges of 900- 1000 °C and 300- 500...
متن کاملEffect of Cutting Parameters on Tool Wear, Surface Roughness and Material Removal Rate During Dry Turning of EN-31 Steel
ISBN 978-93-82338-21-5 | © 2012 Bonfring Abstract--The present paper is an experimental study to investigate the effect of cutting parameters (cutting speed, depth of cut and feed) on tool wear, surface roughness and material removal rate (MRR) during dry turning of EN-31 steel. Turning experiments were conducted with cutting speeds: 250, 300, 350 m/min, feeds: 0.15, 0.2, 0.25 mm/rev and depth ...
متن کاملFatigue Performance of Forged Steel and Ductile Cast Iron Crankshafts
Fatigue is the primary cause of failure of crankshafts in internal combustion engines. The cyclic loading conditions and the stress concentrations in the crank pin fillets are unavoidable, and can result in fatigue failure. The objectives of this study were to compare the fatigue behavior of forged steel and ductile iron crankshafts from a one-cylinder engine as well as to determine if the fati...
متن کاملCheck Tic-coated Tungsten Carbide Tool Wear in Machining Steel
In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Wear
سال: 2021
ISSN: 0043-1648
DOI: 10.1016/j.wear.2021.203737