Torque Sensor based on Magnetostrictive Effect for Automobile Engine
نویسندگان
چکیده
منابع مشابه
Flexible Foot/Ankle Based on PKM with Force/Torque Sensor for Humanoid Robot
This paper describes the development of a novel humanoid robot foot/ankle based on an orientation Parallel Kinematic Mechanism for intelligent and flexible control. With three identical Universal-Prismatic-Spherical prismatic-actuated limbs and a central Universal-Revolute passive limb, the PKM can perform three degrees of freedom rotation motions. In order to enable the humanoid robot safely t...
متن کاملTemperature Distribution Sensor Based on Magnetostrictive Delay Lines
In this paper we propose a new family of temperature distribution sensors based on the magnetostrictive delay line technique. An array of parallel conductors is set orthogonal to the delay line and used for pulsed current transmission. coil is set around the one end of the delay line in order to receive the magneto-elastic pulses. A platinum wire or a thermistor is electrically connected to the...
متن کاملFPGA-Based Cooling Fan Control System for Automobile Engine
In this paper FPGA is used as the master chip to design the new fourphase sensorless BLDC(brushless direct current) motor control system of automobile engine cooling fan. The design uses BEMF zero-crossing detection algorithm and the hardware modular design approach, while the open-loop circuit adopted to raise the frequency and voltage and the digital phase-shift circuit based on FIPS algorith...
متن کاملapplication of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولA Guided Wave Sensor Based on the Inverse Magnetostrictive Effect for Distinguishing Symmetric from Asymmetric Features in Pipes
The magnetostrictive guided wave sensor with a single induced winding cannot distinguish axially symmetric from non-axially symmetric features in a pipe, because it is impossible for the sensor to detect the non-axially symmetric mode waves. When we study the effect of the change of the magnetic field in the air zone for receiving the longitudinal guided wave mode, we find that the change of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Sensors and Micromachines
سال: 1996
ISSN: 1341-8939,1347-5525
DOI: 10.1541/ieejsmas.116.225