Towards Damage Controlled Hot Forming
نویسندگان
چکیده
منابع مشابه
Evaluation of Ductile Damage Criteria in Hot Forming Processes
The process of ductile fracture which occurs due to the accumulation, growth and combination of defects or cracks of material is called ductile damage. Failure in materials can be predicted, using damage mechanics and damage criteria. On the other hand, most of the materials depended to the manufacturing process, are formed in warm or hot conditions so that; the temperature also affects on the ...
متن کاملTowards Superplastic Forming of Az31 Magnesium Alloy with Controlled Microstructure
A recent study on post-superplastic forming properties has shown that heating time prior to testing has a major effect on the post-forming properties of superplastically-formed AZ31 Magnesium alloy sheets. To this point, there has been very little examination into the effects of pre-heating or annealing on superplastic forming. In this work, these effects are examined using AZ31 Mg alloy sample...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملDual–Phase Hot–Press Forming Alloy
Hot–press forming steels are formed in a fully austenitic state followed by die– quenching in order to generate martensite and achieve a strong steel. The ductility however, tends to be limited. We explore in this work a novel steel design in which the forming operation is in the two–phase austenite and ferrite field, so that the quenching results in a dual–phase ferrite and martensite microstr...
متن کاملHot Forming of Aisi A2 Tool Steel
In order to optimize the hot forming process of tool steels, further improvement of flow stress prediction and additional knowledge on hot deformability, especially at lower and upper limits of the hot working range, are required. The hot working ranges for these steels are very narrow as a consequence of the role of alloying elements, which form carbides. Carbides improve tool steel’s hardenab...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Mechanics and Materials
سال: 2018
ISSN: 1662-7482
DOI: 10.4028/www.scientific.net/amm.885.56