Transient Creep of Mild Steel and High-Strength Steel under Bending
نویسندگان
چکیده
منابع مشابه
Bond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملImproved Material Models for High Strength Steel
The mechanical behaviour of the three advanced high strength steel grades, Docol 600DP, Docol 1200M and HyTens 1000, has been experimentally investigated under various types of deformation, and material models have been developed, which account for the experimentally observed behaviour. Two extensive experimental programmes have been conducted in this work. In the first, the dual phase Docol 60...
متن کاملEffect of Spring-back in V-tool Bending of High-strength Steel Sheet Metal Plates
B. Grizelj, J. Cumin, Mechanical engineering Faculty in Slavonski Brod, Slavonski Brod, Croatia D. Grizelj, Siemens, Zagreb, Croatia. This paper deals with the eff ects of technological parameters used in the V-die bending process, on the obtained product properties and dimensions. By variation of the tool geometry, several cases of steel sheet bending process are observed through the FEM simul...
متن کاملDuctile Failure in High Strength Steel Sheets
Developments in computer-aided engineering and the rapid growth of computational power have made simulation-driven process and product development efficient and useful since it enables detailed evaluation of product designs and their manufacturing processes. In the context of a sheet metal component, it is vital to predict possible failure both during its forming process and its subsequent usag...
متن کاملCopper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1963
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.29.674