Transient Heat Transfer for Forced Convection Flow of Helium Gas.
نویسندگان
چکیده
منابع مشابه
Numerical Solution on Transient Heat Transfer for Forced Convection Flow of Helium Gas over a Twisted Plate with Different Helical Pitch
*1: Kobe University, Graduate School of Maritime Sciences, 5-1-1, Fukae-minami, Higashinada-ku, Kobe, JAPAN 658-0022, [email protected], Phone +81-90-3871-9455 *2: Kobe University, Department of Marine Engineering, 5-1-1, Fukae-minami, Higashinada-ku, Kobe, JAPAN 658-0022, [email protected], Phone +81-78-431-6299 *3: Kobe University, Department of Marine Engineering, 5-1-1, Fuka...
متن کاملHeat Transfer Study of Perforated Fin under Forced Convection
Fins are protrusions on a heat transfer surface to augment heat transfer rate from it. The increase in area exposed to convection in case of finned surfaces results in increased heat transfer rate. In this study heat transfer characteristics of a pin fin with perforation is numerically analyzed. A pin fin is fabricated and experiments are done under forced convection conditions. The experimenta...
متن کاملAnalysis of variance of nanofluid heat transfer data for forced convection in horizontal spirally coiled tubes
In the present study, an experimental study is carried out to investigate the effect of adding Al and Cu nanoparticles to the base fluid (water) on the heat transfer rate in a spirally coiled tube. The spirally coiled tube is fabricated from the straight copper tube with the inner and outer coil diameters of 100 and 420 mm, respectively. The experiments have been done for water and two types of...
متن کاملEntropy generation calculation for laminar fully developed forced flow and heat transfer of nanofluids inside annuli
In this paper, second law analysis for calculations of the entropy generation due to the flow andheat transfer of water-Al2O3 and ethylene glycol-Al2O3 nanofluids inside annuli is presented. Thephysical properties of the nanofluids are calculated using empirical correlations. Constant heatfluxes at inner surface of the annuli are considered and fully developed condition for fluid flowand heat t...
متن کاملAn Experimental Study of Heat Transfer During Forced Air Convection
Cast aluminum alloys are usually subject to solution treatment, quenching, and aging hardening for improved mechanical properties. Cooling rate during quenching plays an important role in residual stress, distortion, and mechanical property distributions in the resultant cast aluminum components. As the cooling rates of work pieces heavily depend on the interfacial heat transfer coefficient (HT...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series B
سال: 2002
ISSN: 1340-8054,1347-5371
DOI: 10.1299/jsmeb.45.559