Transitional flow inside enhanced tubes for fully developed and developing flow with different types of inlet disturbances: Part II–heat transfer
نویسندگان
چکیده
منابع مشابه
Entropy generation calculation for laminar fully developed forced flow and heat transfer of nanofluids inside annuli
In this paper, second law analysis for calculations of the entropy generation due to the flow andheat transfer of water-Al2O3 and ethylene glycol-Al2O3 nanofluids inside annuli is presented. Thephysical properties of the nanofluids are calculated using empirical correlations. Constant heatfluxes at inner surface of the annuli are considered and fully developed condition for fluid flowand heat t...
متن کاملentropy generation calculation for laminar fully developed forced flow and heat transfer of nanofluids inside annuli
in this paper, second law analysis for calculations of the entropy generation due to the flow andheat transfer of water-al2o3 and ethylene glycol-al2o3 nanofluids inside annuli is presented. thephysical properties of the nanofluids are calculated using empirical correlations. constant heatfluxes at inner surface of the annuli are considered and fully developed condition for fluid flowand heat t...
متن کاملNumerical Analysis of Fully Developed Flow and Heat Transfer in Channels with Periodically Grooved Parts (TECHNICAL NOTE)
To obtain a higher heat transfer in the low Reynolds number flows, wavy channels are often employed in myriad engineering applications. In this study, the geometry of grooves shapes is parameterized by means of four angles. By changing these parameters new geometries are generated and numerical simulations are carried out for internal fully developed flow and heat transfer. Results are compared...
متن کاملEffects of Rib Shapes on Heat Transfer Characteristics of Turbulent Flow of Al2O3-Water Nanofluid inside Ribbed Tubes
In this paper, convection heat transfer of Al2O3-water nanofluid turbulent flow through internally ribbed tubes with different rib shapes (rectangular, trapezoidal and semi-circular) is numerically investigated. For each rib shape, the optimum geometric ratio and volume fraction were calculated using entropy generation minimization technique. The governing equations in...
متن کاملA General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes
A simple correlation was developed earlier by Kandlikar (1983) for predicting saturated flow boiling heat transfer coefficients inside horizontal and vertical tubes. It was based on a model utilizing the contributions due to nucleate boiling and convective mechanisms. It incorporated a fluid-dependent parameter Ffl in the nucleate boiling term. The predictive ability of the correlation for diff...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Heat and Mass Transfer
سال: 2011
ISSN: 0017-9310
DOI: 10.1016/j.ijheatmasstransfer.2010.11.026