Transported probability density function based modelling of soot particle size distributions in non-premixed turbulent jet flames

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Quantitative three-dimensional imaging of soot volume fraction in turbulent non-premixed flames

A three-dimensional (3-D) imaging system for studies of reactive and non-reactive flows is described. It can be used to reveal the topology of turbulent structures and to extract 3-D quantities, such as concentration gradients. Measurements are performed using a high repetition rate laser and detector system in combination with a scanning mirror. In this study, the system is used for laserinduc...

متن کامل

Modeling soot formation in turbulent kerosene/air jet diffusion flames

Soot volume fraction and number density in a turbulent diffusion flame burning kerosene/air were predicted using two approaches. The first used a conventional soot inception model based on the acetylene concentration and is referred to as the acetylene model. The second used a soot inception model based on the formation rate of three and two ring aromatics [1] and is referred to as the PAH ince...

متن کامل

Laser-induced incandescence for soot particle size measurements in premixed flat flames.

Measurements of soot properties by means of laser-induced incandescence (LII) and combined scattering-extinction were performed in well-characterized premixed ethylene-air flames. In particular, the possibility of using LII as a tool for quantitative particle sizing was investigated. Particle sizes were evaluated from the temporal decay of the LII signal combined with heat balance modeling of l...

متن کامل

Evaluation of a Scalar Probability Density Function Approach for Turbulent Jet Nonpremixed Flames

A scalar probability density function (PDF) method considering a detailed chemical kinetics is applied to a diluted hydrogen turbulent jet nonpremixed flame to evaluate the performance. The flame is formed on a nozzle of an inner diameter of D=6mm, with a fuel exit velocity of 30m/s, surrounded by two annular pipes issuing airs of higher and lower velocities of 30m/s and 3m/s, respectively. The...

متن کامل

Simulation of premixed turbulent flames

1. Introduction Premixed turbulent flames are of increasing practical importance and remain a significant research challenge in the combustion community. These flames have the potential to operate cleanly and efficiently over a broad range of fuels, and therefore to represent a key element in the implementation of low-emissions burners for a variety of industrial applications. However, it is di...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Proceedings of the Combustion Institute

سال: 2019

ISSN: 1540-7489

DOI: 10.1016/j.proci.2018.06.088