Two-Faults Detection and Isolation Using Extended Parity Space Approach
نویسندگان
چکیده
منابع مشابه
Detection of power oscillation and simultaneous faults using Clark transform
Distance relays are widely used to protect transmission lines. Sometimes, in these lines due to the occurrence of the oscillation of the power, the impedance calculated in the distance relay enters into its functional zones and leads to the cutting off of the lines. This issue can cause global power outages. Accordingly, in this paper, a Clark-based method for detecting the oscillation of power...
متن کاملAn Iir Filter Based Parity Space Approach for Fault Detection
In traditional parity space approaches, a parity vector with a low order means a simple online realization but a bad performance, while that with a high order leads to a good performance but an unacceptable calculation amount. In this paper, by introducing a simple scalar IIR (Infinite Impulse Response) filter, a new kind of parity relation based residual generator and the corresponding optimiz...
متن کاملA Unified Nonlinear Adaptive Approach for Detection and Isolation of Engine Faults
A challenging problem in aircraft engine health management (EHM) system development is to detect and isolate faults in system components (i.e., compressor, turbine), actuators, and sensors. Existing nonlinear EHM methods often deal with component faults, actuator faults, and sensor faults separately, which may potentially lead to incorrect diagnostic decisions and unnecessary maintenance. There...
متن کاملFault Detection and Isolation in Systems with Parametric Faults
The problem of fault detection and isolation of parametric faults is considered in this paper. A fault detection problem based on parametric faults are associated with internal parameter variations in the dynamical system. A fault detection and isolation method for parametric faults is formulated in a standard setup and a synthesis method for the fault detector is given. Further, fault detectio...
متن کاملEnhanced detection and isolation of angle of attack sensor faults
An enhanced detection and isolation method to monitor the state-of-practice triplex redundant angle of attack measurements on modern civil transport aircraft is presented. The developed fault detection and diagnosis architecture relies on advanced model and signal based techniques monitoring each of the three sensors individually. This allows the correct isolation of erroneous sensors also in c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrical Engineering and Technology
سال: 2012
ISSN: 1975-0102
DOI: 10.5370/jeet.2012.7.3.411