Ultrafast Heating and Initial Microstructure Effect on Phase Transformation Evolution of a CrMo Steel
نویسندگان
چکیده
منابع مشابه
EFFECT OF COMPOSITION ON PHASE EVOLUTION AND MICROSTRUCTURE OF REACTION BONDED MULLITE (RBM)
Compositions of Al2O3+Si, SiO2+Al and Al+Si systems were prepared to study the effect of reaction bonding process on the mullite formation. The composition of each system was adopted according to mullite stoichiometery and sintered in 700-1600°C range. Results showed that the formation of reaction bonded mullite starting from Al2O3+Si mixtures, proceeded in two partially overlapping steps, the ...
متن کاملEffect of solidification rate on microstructure evolution in dual phase microalloyed steel
In steels the dependence of ambient temperature microstructure and mechanical properties on solidification rate is not well reported. In this work we investigate the microstructure and hardness evolution for a low C low Mn NbTi-microalloyed steel solidified in the cooling rate range of 1-50 Cs-1. The maximum strength was obtained at the intermediate solidification rate of 30 Cs-1. This result h...
متن کاملEffect of Heating Temperature, Heating Time and Initial Microstructure on Recrystallization of Waspaloy during Heating for Forging
Since this project is a result of a class assignment, it has been graded and accepted as fulfillment of the course requirements. Acceptance does not imply technical accuracy or reliability. Any use of the information in this report, including numerical data, is done at the risk of the user. These risks may include catastrophic failure of the device or infringement of patent or copyright laws. T...
متن کاملEffect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy
The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...
متن کاملInvestigating the effects of Magnesia addition on properties, phase transformation and microstructure of gelcasted Zirconia bodies
Magnesia Partially Stabilized Zirconia (Mg-PSZ) is the best material for casting nozzles used in steelmaking industry due to high melting point, high mechanical strength, high thermal shock resistance, high toughness, chemical stability and neutrality, which these nozzles should be fabricated using cold isostatic pressing (CIP) method, however wet processing methods such as gelcasting can lead ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2019
ISSN: 2075-4701
DOI: 10.3390/met9010072