Ultrasonic Fatigue Test of Mild Stee1
نویسندگان
چکیده
منابع مشابه
Enhancing Fatigue Strength by Ultrasonic Impact Treatment
Enhancement in fatigue performance of welded joints by Ultrasonic Impact Treatment (UIT) was evaluated in large-scale specimens having a nominal yield strength of 345 to 690 MPa. Eighteen rolled-beam specimens having welded details at cover plates and transverse stiffeners and eight built-up specimens having only transverse stiffener details were fatigue tested after treating them by UIT. A par...
متن کاملDissipation Measurements during Ultrasonic Fatigue Tests
The aim of this paper is to analyse the dissipation observed during dynamic fatigue loading at low stress range and high number of cycles. Infrared thermographic techniques were developed to estimate the mean dissipation per cycle. Results derived from tests performed at high loading frequency on pure copper specimens showed a drift of dissipative regimes incompatible with concepts of fatigue l...
متن کاملFatigue and ultrasonic testing of epoxy-glass composites
Purpose: The purpose of this paper was to find relationship between the degree of strength degradation caused by fatigue and the changes of ultrasonic wave characteristics such as wave velocity and damping coefficient. Design/methodology/approach: Epoxy-glass composites were subjected to oscillatory bending loadings with constant deflection. During fatigue procedure the force needed to achieve ...
متن کاملImproving Fatigue Strength of Welded Joints by Ultrasonic Impact Treatment
Enhancement in fatigue performance of welded joints by Ultrasonic Impact Treatment (UIT) was evaluated with large-scale rolled beam and built-up specimens having yield strength of 345 to 760 MPa. Eighteen rolled-beam specimens having welded details at cover plates and transverse stiffeners and eight built-up specimens having only transverse stiffener details were fatigue tested after treating t...
متن کاملSimultaneous Ultrasonic Monitoring of Crack Growth and Dynamic Loads during a Full Scale Fatigue Test of an Aircraft Wing
An in situ ultrasonic angle beam method has been developed to detect and size fatigue cracks emanating from fastener holes. The method employs transducers mounted in a pitch-catch configuration on each side of the hole, and the modulation of received signals with load is used to detect and size small fatigue cracks. The focus of this paper is the monitoring of a series of critical fastener hole...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1981
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.24.1708