Ultrasonic Testing of Rough Surfaces Using Phased Array Probe
نویسندگان
چکیده
منابع مشابه
Quantitative Ultrasonic Testing of Pressurized Components Using Sampling Phased Array
Ultrasonic testing and evaluation procedures typically depend on reference reflectors to establish detection sensitivity and evaluation of test data. Rules and regulations governing safety-related components emphasize on test procedures that assure the detectability of discontinuities at all over the component and oriented in any arbitrary direction. Existing procedures, however, do not provide...
متن کاملApplication of Phased Array Ultrasonic Testing Technology on Inservice Wheel
In this paper, an Ultrasonic testing method for inservice wheel by use of phased array technology is introduced. To meet the ultrasonic test criterion of inservice CRH wheel, groups of phased array probes and conventional probes are combined used. By study echo wave in wheel rim and wheel disk form different probes, defect analyzing methods in wheel rim and wheel disk are studied. Tests on CRH ...
متن کاملPhased array ultrasonic imaging using an improved beamforming based total focusing method for non destructive test
One of the novel ultrasonic phased array based scanning methods for ultrasonic imaging in non-destructive test is total focusing method (TFM). This method employs maximum available information of the phased array elements and leads to an improved defect detection accuracy compared to conventional scanning methods. Despite its high detection accuracy, TFM behaves weak in distinguishing the real ...
متن کاملPhased array antenna using MEMS phase shifter
This article presents a phased array antenna employing MEMS phase shifter. The proposed phased array antenna consists of eight square patch antennas operating at 10.4 GHz with a bandwidth of 400 MHz. Feed line for each patch passes through a MEMS phase shifter realized by a series of bridges above the transmission line. The distance between the bridge and the transmission line underneath it is ...
متن کاملNon-Destructive Inspection of Components with Irregular Surfaces using a Conformable Ultrasonic Phased Array
A conformable phased array device is being developed that allows reliable ultrasonic inspection of components with irregular surfaces. The device uses a standard linear phased array transducer, which is coupled to the surface under test by a water path, encapsulated by a low loss, synthetic rubber membrane. A comparison of results obtained using conventional ultrasonic techniques and the confor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Sciences
سال: 2021
ISSN: 1312-5702
DOI: 10.7546/engsci.lviii.21.01.05