Utilizing swelling force to decrease the ice adhesion strength
نویسندگان
چکیده
منابع مشابه
Dynamic force spectroscopy to probe adhesion strength of living cells.
We studied the mechanical strength of the adhesion of living cells to model membranes. The latter contained a RGD lipopeptide which is a high affinity binding site for a cell adhesion molecule (integrin alpha(V)beta(3)). Cells adhered specifically to the vesicles. We used micropipette aspiration for breaking this adhesion with well defined forces. Systematic variation of the rate of force appli...
متن کاملForce generated by a swelling elastomer subject to constraint
When an elastomer imbibes a solvent and swells, a force is generated if the elastomer is constrained by a hard material. The magnitude of the force depends on the geometry of the constraint, as well as on the chemistry of the elastomer and solvent. This paper models an elastomer crosslinked on the exterior surface of a metallic tubing. The elastomer then imbibes a solvent and swells. After the ...
متن کاملModeling of the intermolecular Force-Induced Adhesion in Freestanding Nanostructures Made of Nano-beams
Among the intermolecular interactions, the Casimir and van der Waals forces are the most important forces that highly affect the behavior of nanostructures. This paper studies the effect of such forces on the adhesion of cantilever freestanding nanostructures. The nanostructures are made of a freestanding nano-beam which is suspended between two upper and lower conductive surfaces. The linear s...
متن کاملCell adhesion force microscopy.
The adhesion forces of cervical carcinoma cells in tissue culture were measured by using the manipulation force microscope, a novel atomic force microscope. The forces were studied as a function of time and temperature for cells cultured on hydrophilic and hydrophobic polystyrene substrates with preadsorbed proteins. The cells attached faster and stronger at 37 degreesC than at 23 degreesC and ...
متن کاملVision and Force Sensing to Decrease Assembly Uncertainty
This paper presents two ways of decreasing the assembly uncertainty of micro assembly tasks through further or optimized integration of sensors within a size adapted assembly system. To accomplish this, the orientation of the part to be placed with respect to the vision sensor is changed. This was possible through a new gripper which was able to overcome the restrictions placed on the system by...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Cold Regions Science and Technology
سال: 2018
ISSN: 0165-232X
DOI: 10.1016/j.coldregions.2017.11.018