Vanadium bioavailability in soils amended with blast furnace slag
نویسندگان
چکیده
منابع مشابه
Ground Granulated Blast Furnace Slag
1. Ground Granulated Blast Furnace Slag Ground Granulated Blast Furnace Slag (GGBFS) is a by product of the steel industry. Blast furnace slag is defined as “the non-metallic product consisting essentially of calcium silicates and other bases that is developed in a molten condition simultaneously with iron in a blast furnace.” [1] In the production of iron, blast furnaces are loaded with iron o...
متن کاملProperties of Foamed Mortar Prepared with Granulated Blast-Furnace Slag
Foamed mortar with a density of 1300 kg/m³ was prepared. In the initial laboratory trials, water-to-cement (w/c) ratios ranging from 0.54 to 0.64 were tested to determine the optimal value for foamed mortar corresponding to the highest compressive strength without compromising its fresh state properties. With the obtained optimal w/c ratio of 0.56, two types of foamed mortar were prepared, name...
متن کاملBioavailability of heavy metals in soils amended with sewage sludge
Morera, M. T., Echeverría J. and Garrido, J. 2002. Bioavailability of heavy metals in soils amended with sewage sludge. Can. J. Soil Sci. 82: 433–438. The recycling of sewage sludge to agricultural land results in the slow accumulation of potentially toxic heavy metals in soils. A greenhouse experiment was conducted to determine the bioavailability of Cu, Ni, Pb and Zn applied to soils in urban...
متن کاملThe Study of Ion Adsorption by Amorphous Blast Furnace Slag
In this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. For this reason, various experimental parameters such as pH, contact time and the primary ion concentration were investigated. The remaining concentrations of ions such as; Mn2+ and Fe2+ in water were measured by atomic adsorption spectroscopy. The chemical and p...
متن کاملCeramics from blast furnace slag, kaolin and quartz
Three new ceramic batches with no traditional fluxes and 30, 50 and 70 wt.% blast furnace slag were studied. The processes of phase formation and densification were estimated in non-isothermal conditions by differential thermal analysis and dilatometry, respectively. After that the degrees of sintering, obtained after heat-treatment at different temperatures and times, were evaluated measuring ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Hazardous Materials
سال: 2015
ISSN: 0304-3894
DOI: 10.1016/j.jhazmat.2015.04.034